OpelBook.ru
Cars AvtoVAZ Cars Mitsubishi Cars BMW Cars Mercedes Cars Nissan Cars Toyota Cars Chevrolet
English Русский
Български
Беларускі
Український
Српски
Hrvatski
Română
Polski
Slovenský
Magyar
 |  Sitemap  |  Contacts  |    

 
 
 
 
 
 
 
 
 
Main Astra Corsa Insignia Kadett Omega Vectra Zafira Others Articles
Kadett D (1979-1984) Kadett E (1984-1995)
  • Main
  • Kadett
  • Kadett E

Car repair and maintenance Opel Kadett E

This guide is intended for employees of centers and service stations and "garage" workshops, as well as for technically advanced motorists. Therefore, the detailing of repair operations is not too deep and you should easily understand it.

The following articles provide maintenance and repair instructions for 1984-1995 Opel Cadet E-series vehicles with engines of the 12S, 13N, 13S, 14NV, 16S, 16SV, 18E, 18SE, 20NE, 20SEH, 20XE, C16NZ, C20NE and with all body types.

See this manual on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

General information
Vehicle description
Car wheels and tires
Overall dimensions of cars
Mass characteristics of cars
Conventional fuel consumption
Filling tanks and used fuels and lubricants
Full list of articles in this category »
Operation and maintenance
Introduction to the Kadett E vehicle operating manual
Vehicle Passport Data
Lifting and towing a car
Designation of some vehicles
General requirements for car repair
Full list of articles in this category »
OHV power unit
Engine design
Main technical characteristics
Cylinder head specifications
Technical characteristics of the cylinder block
Technical characteristics of the crank mechanism
Technical characteristics of the valve timing mechanism
Full list of articles in this category »
Check and repair
Adjusting clearances in the valve drive mechanism
Removal and installation the ignition system distributor
Adjusting the gap between the contacts of the ignition system interrupter
Setting the ignition timing
Fuel pump
Full list of articles in this category »
Engine work
Removal the cylinder head
Installing the cylinder head
Disassembling the cylinder head
Checking the cylinder head
Grinding of valve seats and valves
Full list of articles in this category »
OHC power unit
Engine design
Main technical characteristics
Technical characteristics of the 8-valve cylinder head
Technical characteristics of the 16-valve cylinder head
Technical characteristics of the cylinder block
Technical characteristics of the crank mechanism
Full list of articles in this category »
Engine repair
Adjusting clearances in the drive mechanism
Construction of hydraulic tappets
Operating principle of hydraulic tappets
Checking the technical condition of hydraulic tappets
Removal the cylinder head of 8-valve engines
Full list of articles in this category »
Ignition system
Contactless ignition system device
The principle of operation of a contactless ignition system
Fully electronic ignition system
Ignition distributor sensor device
Scheme for troubleshooting and troubleshooting contactless ignition system
Full list of articles in this category »
Cooling and lubrication
Lubrication system
Lubrication system device
Cooling system
Cooling system device
Full list of articles in this category »
Supply system
Fuel system of carburetor engines
The principle of operation of the Solex 35 PDSI carburetor
Air filter device
Adjustment and check of carburetor Solex 35 PDSI
Automatic starting device for GM Varajet II carburetor
Full list of articles in this category »
Fuel injection «LE-Jetronic»
Features of the device and operating principle
Fuel injection system «LE-Jetronic»
Checking and adjusting the LE-Jetronic system
Checking the additional air supply valve
Checking injection nozzles
Full list of articles in this category »
Fuel injection «LE3-Jetronic»
Fuel injection system «LE3-Jetronic»
Checking and adjusting the «LE3-Jetronic» system
Test sequence for determining faults in the fuel injection system «LE3-Jetronic»
Full list of articles in this category »
Motronic ML4.1 system
Distinctive components of the Motronic ML4.1 system from LE-Jetronic
The structure of the system «Motronic ML4.1»
Operating principle
Warnings: Checking and adjusting the fuel injection system
Checking and adjusting engine idle speed
Full list of articles in this category »
Motronic M1.5 system
Digital engine management system «Motronic M1.5»
Malfunctions and methods of their elimination
Full list of articles in this category »
Motronic M2.5 system
Digital engine management system «Motronic M2.5»
Possible malfunctions of the digital engine control system «Motronic M 1.5», their causes and methods of elimination
Fuel injection system
Ignition system
Malfunctions and methods of their elimination
Full list of articles in this category »
Transmission
Clutch
Design and technical characteristics
Tightening torques of main threaded connections, kgf.m
Removal and installation the clutch
Clutch device
Full list of articles in this category »
Gearbox F10 and F13
Design and technical characteristics
Tightening torques of main threaded connections, kgf.m
Removal and installation the gearbox
4-speed gearbox device
Disassembling a 4-speed gearbox
Full list of articles in this category »
Gearbox F16 and F20
Design and technical characteristics
Tightening torques of main threaded connections, kgf m
Removal and installation the gearbox
Disassembling the gearbox
The device of the 4-speed gearbox type «F16»
Full list of articles in this category »
Automatic gearbox
Design and technical characteristics
Gearbox specifications
Technical characteristics of transmission oil
Tightening torques of main threaded connections, kgf.m
Design features and operating principle
Full list of articles in this category »
Drive shafts
Design and technical characteristics
Tightening torques of main threaded connections, kgf m
Removal and installation front wheel drive shafts
Replacing the front wheel drive shaft joints
Replacement of protective covers of wheel drive shaft joints
Full list of articles in this category »
Chassis
Front suspension
Design and technical characteristics
Technical characteristics of the anti-roll bar
Technical characteristics of front wheel hubs
Tightening torques of main threaded connections, kgf.m
Removal and installation a telescopic stand
Full list of articles in this category »
Rear suspension
Design and technical characteristics
Tightening torques of main threaded connections, kgf m
Removal and installation rear suspension springs
Removal and installation rear suspension springs
Replacing rear suspension shock absorbers
Full list of articles in this category »
Steering
Mechanical steering specifications
Technical characteristics of power steering
Tightening torques of main threaded connections, kgf.m
Removal and installation of the steering gear of the mechanical steering
Disassembly and assembly of the steering mechanism of mechanical steering
Full list of articles in this category »
Brake system
Design and technical characteristics
Technical characteristics of the front wheel brake mechanisms
Technical characteristics of rear wheel drum brakes
Technical characteristics of wheel cylinders
Technical characteristics of rear wheel disc brakes
Full list of articles in this category »
Electrical equipment
Equipment and devices
Technical characteristics of the battery
Generator specifications
Starter specifications
Technical characteristics of fuses
Tightening torques of main threaded connections, kgf m
Full list of articles in this category »
Electrical circuits
Wire color designation
Electrical Equipment Diagram No.1
Electrical Equipment Scheme No.2
Electrical Equipment Diagram #3
Electrical Equipment Diagram No.4
Full list of articles in this category »

Share information:

Kadett E (1984-1995) 
  • General information
  • Vehicle description
  • Operation and maintenance
  • OHV power unit
  • Engine design
  • Check and repair
  • Engine work
  • OHC power unit
  • Engine design
  • Engine repair
  • Ignition system
  • Cooling and lubrication
  • Supply system
  • Fuel injection «LE-Jetronic»
  • Fuel injection «LE3-Jetronic»
  • Motronic ML4.1 system
  • Motronic M1.5 system
  • Motronic M2.5 system
  • Transmission
  • Clutch
  • Gearbox F10 and F13
  • Gearbox F16 and F20
  • Automatic gearbox
  • Drive shafts
  • Chassis
  • Front suspension
  • Rear suspension
  • Steering
  • Brake system
  • Electrical equipment
  • Equipment and devices
  • Electrical circuits
Kadett D (1979-1984) 
  • General information
  • Car care
  • Maintenance
  • Power unit
  • Gasoline engines
  • Lubrication system
  • Cooling system
  • Power system (gasoline)
  • Carburetor Solex 35 PDSI
  • Carburetor Varajet II
  • Carburetor 1B1
  • Fuel injection (gasoline)
  • Diesel engines
  • Fuel system (diesel)
  • Transmission
  • Clutch
  • Manual gearbox
  • Chassis
  • Front suspension
  • Rear suspension
  • Steering
  • Brake system
  • Wheels and tires
  • Body
  • Body elements
  • Doors and windows
  • Electrical equipment
  • Equipment and devices
  • Lighting system
  • Power devices
  • Ignition system
  • Electrical circuits
OpelBook.ru © 2017–2026 · Mobile version · · Sitemap: EN BG BY UA RS HR RO PL SK HU · Feedback · Site search
Astra F, petrol · Astra G, petrol · Astra G · Astra H · Astra J, petrol · Corsa B · Corsa C, petrol · Corsa C · Insignia A · Kadett D · Kadett E · Omega A · Omega B · Omega B2 · Vectra A, petrol · Vectra A · Vectra B, petrol · Vectra B · Vectra C · Zafira A, petrol · Frontera A, petrol · Frontera B · Ascona C · Vivaro A ·
We want your visit to be comfortable 🤝! We use cookies 🍪 to make that happen.