Elements of the car body Opel Kadett D

General description of the car body
The body of the OPEL KADETT D is load-bearing. The floors, roof, side sections and rear wings are welded together. Therefore, major damage to the body can only...

Removal and installation the bumper
Removal The bumper is attached to the body with 8 bolts. Unscrew the hex bolt on each side from the inside of the wing in the corner with the rod and in the...

Removal and installation the front wing
Removal 1 - side, 2 - fairing, 3 - hinged stand (A stand) Remove the bumper. If there is an antenna, unscrew it from the wing. Unscrew the wheel bolts, jack up...

Removal and installation the radiator grille
Removal Detach the top edge of the protective grille (four holders). Remove the grate from the three slots at the bottom. Installation Place the grille at the...

Additional installation of protective moldings
Mark the mounting points for the rivets for the protective moldings. Drill the holes with a 2.5 mm drill. 1 - a car with 2 doors 2 - a car with 4 doors...

Heater — design description
A - channel for fresh air under the fairing; B - engine with fan impeller; C - air distributor housing; D - air distributor flap; E - air distribution flap; F...

Removal and installation fresh and heated air regulator/replacing rods
Removal Disconnect the heater rods located under the instrument panel from the air distributor housing. A - heater rod 260 mm long, B - air distribution rod...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

See similar ones from other Opel car manuals:
▶ Body: Body elements Opel Vectra A (1988-1995, petrol)
▶ Body: Body elements Opel Omega B2 (1999-2003)

Share information: