Gearbox — general description The gearbox forms a single unit with the differential. The unit in the kit can be removed without removing the engine. It is also possible to remove only the...
F16 gearbox — removal Remove the clutch cable from the groove of the retainer and disconnect it from the clutch release lever. Disconnect the reversing light switch wire. GTE:...
F10 gearbox — removal Pull out the drive shaft from the left side of the gearbox housing. Press out the drive shaft on the right side of the gearbox with a pry bar. Attention: After...
Gearbox — installation If the differential cover was removed, install the cover with a new seal. Stick the grease seal onto the cover. Tighten bolts to 30 Nm. Screw gearbox housing...
Gear Lever — Design Description The figure shows the shift lever with the F10 box: 1 - Speedometer drive, 2 - Oil filler plug, 3 - Pin, 4 - Rod, 5 - Cardan joint, 6 - Shift rod (rear), 7 -...
Removal and installation of the gear lever Removing Set the shift lever handle to the neutral position. Unscrew the console from the tunnel. Remove the rubber cover from the switch lever. Pull the lever...
Switch adjustment The illustrations show the F16 box. Set handle to neutral position. Unscrew and remove the console. Loosen the bolt securing the clamping collar of the...