Design and specifications Front suspension independent, type «rocking candle», telescopic with hydraulic shock absorbers (on vehicles with engine «20XE» gas-filled shock absorbers),...
Technical characteristics of the stabilizer bar Diameter of the stabilizer bar Note. On vehicles with engine «20XE» the diameter of the cross bar is 22 mm. Front wheel alignment* *The front wheel alignment...
Specifications of the front wheel hubs The front wheel hub is mounted on a double-row ball bearing. To adjust the clearance in the bearings, tighten the hub nut to a torque of 2.0 kgf·m, and then...
Removal and installation of a telescopic rack Removing Raise the front of the car. put on stands and remove the front wheel. Remove the front wheel brake caliper and hang it on the technological hook to...
Front suspension device Front suspension details: 1 - suspension arm; 2 - front suspension strut housing, made integral with the steering knuckle; 3 - shock absorber; 4 - suspension...
Removal and installation of front suspension springs Remove the telescopic strut and strut top support, upper spring support cup, spring with insulating gasket as above. Release and remove the spring. Install a...
Removal and installation of suspension arms Removing Raise and support the front of the vehicle and remove the front wheel. Disconnect the end of the anti-roll bar from the suspension arm. Disconnect the...
Replacing the ball joints of the suspension arms Removing Remove suspension arm. Using a 12 mm drill, drill out the heads of the three rivets securing the ball joint of the lever and remove the joint....
Replacement of silent blocks of suspension arms Remove suspension arm. Press out the rear silent block using tool KM 307. Using tools KM 158/5 and KM 117/3, press out the front silent block in the direction...
Front wheel bearing replacement Remove the telescopic pole. Loosen the brake disc mounting bolt and remove the disc. Using tool KM 466 5, press out the hub (see photo). In this case, the...