Car front suspension Opel Vectra A

Front suspension and axle shafts. Design and general information
The front wheels of the Opel Vectra are mounted on struts connected to the body by transverse levers. During repairs, the front struts are removed as a set....

Removal and installation the front pillar
Removal Engage any gear, apply the parking brake. Remove the cotter pin and unscrew the hub crown nut. Attention! The car must be on the ground, otherwise it...

Removal and installation the shock absorber and front spring
Attention! Shock absorbers can be replaced separately, but springs can only be replaced in pairs. Removal Remove the front pillar. To release the shock...

Checking the shock absorber
The following signs indicate a faulty shock absorber: prolonged vibrations of the body when driving on an uneven road; strong rocking of the body on uneven...

Removal and installation axle shafts
When retracting the protective cover, the axle shaft does not need to be removed. You only need to remove the small clamp and lift the cover with a...

Replacement of axle joint and joint boot
Defective protective covers must be replaced immediately. Replacement requires disassembling the axle shaft. If dirt gets into the grease, wash the joint in...

Removal and installation front wheel hub bearings
Signs of defective bearings are: knocking on sharp turns, difficulty turning the wheel when the brakes are released. The bearings are installed in such a way...

Removal and installation the front suspension beam
Removal In vehicles with a catalytic converter: disconnect the connector from the lambda probe, having first removed the expansion tank for the coolant and...

Front Suspension Maintenance
The front suspension does not require any maintenance. Only the following visual checks should be performed periodically. The front suspension must be...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: