Replacing the front wheel hub bearing (Opel Kadett E)

Remove the telescopic stand.

Loosen the brake disc mounting bolt and remove the disc.

Using the KM 466 5 device, press out the hub (see photo). This will destroy the bearing and half of the inner bearing ring will remain in the hub.



Remove the brake disc protective cover.

Remove the two bearing retaining rings from the steering knuckle (see photo).



Press out the outer ring of the ball bearing using the KM 466 4, KM 466 5 and KM 466 2 tools.

Using the KM 466 1 device, press out the second half of the inner bearing ring from the wheel hub (see photo).



Clean the hole in the hub, press the outer bearing ring into the hub first, then the inner bearing ring.



Install the snap rings with the ends of the outer snap ring facing down.

Bolt the brake disc guard onto the steering knuckle.

Press the hub (see photo).



Install the brake disc.

Install the telescopic stand in place.