2. Remove the rear suspension spring.
3. Remove the rear brake disc.
4. To turn away the bottom fastening of the shock-absorber.
5. Unscrew the outer mounting of the lower suspension arm.
6. Install the CH-49376 key on the wheel hub with bearing assembly and fix with wheel nuts, then unscrew the rear wheel drive shaft mounting nut. When installing, use a new nut.
Note.
- Replace the drive shaft mounting nut with a new one after each removal.
- Tightening torque: 150 Nm + 45°+ 250 Nm.
7. Using the CH-49400 puller, initially disconnect the drive shaft from the wheel hub with bearing.
8. Remove the three mounting bolts (1) rear wheel hub.
Note. Replace bolts with new ones after each removal. Tightening torque: 90 Nm + 60°+ 15°.
9. Remove adjusting rod (3) rear suspension.
10. Installation is made in an order, the return to removal.
Note. Make sure the platter is correctly positioned during installation.
Visitor comments