2. Remove the rear wheels from the vehicle.
3. Unscrew the nut with washer of the internal fastening of the adjusting rod.
4. Support the vehicle's fuel tank using a suitable hydraulic jack.
5. Unscrew the outer fastener and remove the fuel tank clamp.
6. Lower the fuel tank to gain access to the bolt (1) internal fastening of the adjusting rod.
7. Loosen the bolt (1) internal fastening of the adjusting rod.
Note. Tightening torque: 150 Nm.
8. Loosen the bolt (2) external fastening of the adjusting rod.
Note. Replace bolt (2) new after each removal. Tightening torque: 150 Nm + 60°+ 75°.
9. Remove adjusting rod (3) rear suspension.
10.Installation is made in the reverse order of removal.
Note. A suitable hydraulic jack must be used to relieve the suspension while tightening the screw connections.
11. After installation, check and adjust the rear wheel alignment angles.
Visitor comments