2. Remove the rear wheel from the vehicle.
3. Unscrew the inner fastener (1) rear upper control arm.
Note.
- Tightening torque: 150 Nm.
- Tighten the nut while holding the bolt from turning.
4. Unscrew the outer fastener (2) rear upper control arm.
Note.
- Replace the rear upper control arm outer bolt with a new one after each removal.
- Tightening torque: 115 Nm + 90°+ 15°.
- Tighten the nut while holding the bolt from turning.
5. Remove the wire harness clamps from the suspension arm.
6. Remove the upper arm of the rear suspension (3) from the car.
7. Installation is made in an order, the return to removal.
Note. A suitable hydraulic jack must be used to relieve the suspension while tightening the screw connections.
8. After installation, check and adjust the angles of the rear wheels.
Visitor comments