Car interior Opel Insignia A

Replacing the instrument panel assembly
1. Deactivate the additional passive safety system. 2. If equipped, remove the front passenger airbag switch (1) and disconnect the electrical connector. 3....

Windshield Blower Nozzle Replacement
1. Using a plastic spatula, release the eight fasteners (1) and remove the windshield blower nozzle (3). 2. Disconnect all electrical connectors. 3. Remove the...

Replacing the upper center trim panel
1. Using a flat plastic spatula, release the four retaining clips (1) of the top centre trim panel, starting from the bottom. 2. Disconnect the electrical...

Replacing the lower center trim panel
1. Remove the ashtray (1). 2. Using a flat spatula, detach the ashtray housing (2) from the instrument panel and disconnect the electrical connectors. 3. Using...

Replacing the headlight switch trim
1. Open the storage compartment on the driver's side. 2. Disconnect the electrical connectors. 3. Loosen the two mounting bolts and use a spatula to detach the...

Replacing the dashboard strut
1. Remove the instrument panel assembly. 2. Remove the door sill trims from the front and rear doors on both sides of the vehicle. 3. Remove the steering...

Replacing the front floor console
1. Loosen the six screws (1) and remove the front floor console (2). Note: To remove the screws securing the front floor console, move the front seats to the...

Replacing the Trim Frame of a Ceiling Reading Lamp
Using a flat spatula, carefully pry the clips loose and remove the ceiling reading lamp.

Replacement of the ceiling console
1. Remove the sunroof drive trim cover. 2. Remove the anti-theft system sensor molding. 3. Remove the ceiling reading lamp trim frame. 4. Remove the ceiling...

The device of the interior trim panels
1. Windshield pillar trim. 2. Front door trim panel. 3. Upper trim of the central body pillar. 4. Lower trim of the central body pillar. 5. Rear door trim...

Replacing the front and rear door sill trims
1. Remove the six fasteners (1). 2. Disconnect the electrical connectors and remove the front and rear door sill trims (2). 3. Installation is carried out in...

Replacing the windshield pillar trim
Removal Attention. If the vehicle is equipped with a curtain airbag, make sure that the curtain airbag module and the limiter are not damaged. If any damage or...

Replacement of the lower and upper trims of the central body pillar
1. Remove the front and rear door sill trims. 2. Pull the front ceiling grab handle down and, holding it in this position, use a small screwdriver to unhook...

Replacing the ceiling panel
Attention. Do not attempt to repair or replace the impact absorbing material bonded to the headliner and pillar trims. If the material is damaged, replace the...

Replacing the front floor covering
1. Remove the driver's or front passenger's seat. 2. Remove the front floor console. 3. Remove the front and rear door sill trims. 4. Remove the front floor...

Replacing the rear floor covering
1. Remove the driver's or front passenger's seat. 2. Remove the rear seat. 3. Remove the front floor console. 4. Remove the front and rear door sill trims. 5....

Replacing the interior door trim
Removal 1. Front doors: remove the exterior rearview mirror mounting trim (1). 2. Using a small flat-head screwdriver or similar tool, pry up the corner (1) to...

Replacing door waterproofing
1. Remove the inner door trim. 2. Remove the door waterproofing (1), passing the electrical connectors and door release cable through the holes in it. Front...

Replacing the door frame trim
1. Remove the inner door trim. 2. Pull the inner front part of the door frame trim away from the inner window flange and release the clips (1). Front door Rear...

Special tools and accessories

Tightening torques for threaded connections

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: