Car clutch repair Opel Insignia A

General information
Vehicles equipped with manual transmissions are equipped with a dry single-disc clutch with hydraulic drive. Power is transmitted from the flywheel on the...

Bleeding the clutch hydraulic drive
Caution. Do not mix the clutch hydraulic fluid with mineral oils and lubricants. Even a small amount of them can cause clutch malfunction or breakage. Note:...

Replacing the clutch pedal position sensor
Removal 1. Disconnect the clutch pedal position sensor wire connector. 2. Loosen the bolt (2) and remove the clutch pedal position sensor (1). Installation 1....

Replacing the clutch master cylinder
1. Remove the lower instrument panel trim insulator. 2. Remove the cruise control switch from the clutch pedal. 3. Remove the expansion tank of the cooling...

Replacing the clutch slave cylinder line
Removal 1. Remove the gearbox. 2. Disconnect the pressure line (1) from the clutch slave cylinder and unscrew the bolt (2). 3. Remove the pressure pipe...

Replacing the clutch slave cylinder
1. Raise and secure the vehicle. 2. Remove the gearbox. 3. Gearbox F40: Disconnect the pipe from the clutch slave cylinder. 4. Loosen the three bolts securing...

Replacing the clutch slave cylinder (LDE/A16XER, 2H0/A18XER engines)
Removal 1. Remove the gearbox. 2. Remove the retaining sleeve (1) of the pressure pipeline: Unlock the locking sleeve in the clutch housing (arrows). Carefully...

Replacing clutch discs
Removal 1. Remove the gearbox. 2. Connect the DT-6263 remover and installer (1) to the engine cylinder block. Note: The DT-6263 remover/installer must be...

Specification

Special tools and accessories

Operating materials

Tightening torques for threaded connections

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: