Removing
1. Remove the gearbox.
2. Remove the fixing sleeve (1) pressure pipeline:
- Unlock the locking sleeve in the clutch housing (arrows).
- Carefully remove the retaining sleeve from the gearbox.
- Detach the fixing sleeve of the pressure pipe.
- Gently squeeze the two locking tabs (3).
3. Unscrew the three mounting bolts (arrows) and remove the release bearing (1) with pressure pipeline.
Installation
1. Clean threaded holes (1) in the gearbox housing.
2. Install the pressure pipe fixing sleeve.
Note. Pay attention to the installation position.
3. Install clutch slave cylinder (1) with hydraulic line:
Note. Use new bolts. It is important to prevent the clutch slave cylinder from being angled.
- Insert the hydraulic line into the sleeve.
- Apply a thin coat of gear oil to the clutch slave cylinder o-ring.
- Screw in the three fastening bolts evenly until they touch the flange.
- Tighten the three clutch slave cylinder bolts to 6 Nm.
4. Install the gearbox.
Visitor comments