Since 09.1995, design changes have been made to the clutch drive cable, the cable guide to the pedals and the damping element at the clutch rocker arm.
1. If noise is heard from under the instrument panel when you press the clutch pedal, the cause is usually insufficient lubrication of the clutch drive cable.
2. At the same time, press the clutch pedal up and lubricate the hook of the drive cable, as well as the groove of the clutch pedal at the point where the cable is attached, with OPEL ET-No. 90001825 grease.
3. Use a ruler to measure the length of the clutch release lever thread to the adjusting screw and record the measurement to make it easier to adjust the new clutch cable.
Measuring the thread length of the clutch release lever
4. Use a screwdriver to remove the locking clip from the threaded element of the clutch cable.
Locking bracket
5. Press the clutch release lever with a crowbar and disconnect the cable. Press the cable out of the holder.
6. Disconnect the return spring and clutch cable from the clutch pedal.
Removal the return spring and clutch cable from the pedal
7. Pull the cable out from the engine compartment bulkhead.
8. Installation is carried out in the reverse order. Make sure that the cable lies correctly in the guide.
9. Adjust the clutch cable.
10. Connect the cable to the holder.
[Original source on the website Opelbook.ru]
Visitor comments