Car wheel suspension Opel Corsa C (petrol)

Possible suspension and wheel faults
Possible malfunctions, their causes and methods of elimination

General information about the suspension
The suspension is the link between the body and the wheels. Through it, the forces acting on the wheels are transmitted to the body. The suspension serves to...

Chassis adjustment values
Note: Values are valid for vehicles with 70 kg load on both front seats and a half-filled fuel tank. Wheel alignment angles Wheel alignment angles * positive...

Removal and installation the front axle stabilizer
Removal Remove the front axle housing. Remove the stabilizer. Mark the position of the stabilizer in relation to the front axle housing. Remove bearing...

Removal and installation the front steering knuckle
Removal Remove the front wheel. Mark the position relative to the wheel hub. Removing the axle shaft from the wheel hub. Remove the dust cap. Note: The dust...

Removal and installation the front control arm of the independent suspension
Removal Remove the front wheel. Mark the position relative to the wheel hub. Remove the guide joint from the steering knuckle. Remove screw 1. Remove the...

Replacing all rubber bearings of the front stabilizer
Removal Attention! Before removing the front axle housing, it is necessary to ensure that the engine shock absorber blocks are correctly secured. Before...

Removal and installation the front shock absorber strut with shock absorber
Removal Remove the upper nut 2 from the shock absorber strut. Remove protective cap 1 from the shock absorber. Remove the front wheel. Mark the position...

Disassembly and assembly of the shock absorber strut
Note: Replace springs and shock absorbers in pairs only. Removal Remove shock absorber strut 1. Place the KM-6066 2 fixture on a workbench or clamp it in a...

Checking the angular clearance of the rear wheel bearing assembly
Remove the rear brake disc. Install the KM-468-B 2 or KM-6610 tool with two wheel bolts 1 on the wheel hub of the wheel bearing assembly. Install the MKM-571-B...

Removal and installation the rear axle
Removal Move the safety flap 2 of the main brake cylinder upward. Remove seal 1 from the water tank as much as necessary. Remove cap 3 from the brake fluid...

Removal and installation the rear stabilizer
Removal Remove the 2 rear wheels. Note: Mark the position relative to the drum hub. Remove 2 screws 1 securing the stabilizer on the rear axle. Note: Make sure...

Removal and installation the rear shock absorber
Note: Shock absorbers are removed and installed only one after the other on each side of the vehicle. Note: The following describes removal and assembly on one...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: