Car steering Opel Corsa C (petrol)

Possible steering malfunctions
The vehicle has electro-hydraulic power steering (EPS), which ensures optimal performance in all conditions. Possible malfunctions, their causes and methods of...

Operating principle of EPS
Electro-hydraulic power steering reduces the effort required to operate the steering gear. The hydraulic system operates in the same way as the power steering...

Steering column cover
The new steering column cover is adjustable in length and tilt. The steering column can be adjusted in length by 50 mm, and in tilt by 40 mm. The steering...

Steering gear / steering rods
The steering mechanism is rack and pinion. The steering mechanism is connected to the front suspension subframe via damping bushings. There are two different...

Checking the steering wheel play
With the vehicle stationary and the wheels set to the straight-ahead position, rock the steering wheel from side to side with a little effort. If the play...

Checking the steering wheel effort
Note: Before performing the inspection, check the tire pressure, tire type and contact surface. Set the steering wheel to the center position. Remove the...

Bleeding the power steering system
Check the level of working fluid in the tank. Raise the front of the vehicle and support it on stands. With the engine off, turn the steering wheel from lock...

Checking the tie rod ends and seals
Raise the car so that the front wheels are suspended. The steering rod ends are secured in the sockets of the levers on the right and left of the axle housing....

Testing constant velocity joints
Turn the steering wheel to any side until it stops. The joints are firmly seated in plastic inserts of the steering arms filled with long-term grease. They are...

Checking the tightness of the power steering
Open the clamps on the covers and slide the covers towards the steering gear. Start the engine. Note: Do not perform this check for more than 5 seconds,...

Checking the power steering fluid level
Set the car wheels to the straight position. If the working fluid in the hydraulic system has cooled down, the engine should not be started. You can also check...

Troubleshooting in operating conditions
Noises and knocks in the steering while driving The cause of the malfunction may be too much play in the steering gear bearing bushing. Troubleshooting If a...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: