Car clutch repair Opel Corsa C

Clutch and Gearbox Specifications
Clutch Type - Single-disc, dry, with diaphragm spring and hydraulic drive Driven diameter (friction) disk, mm: For engines Z10XE(P/Z12XE(P) — 190 For...

General information about manual transmission
The transmission housing is made from cast aluminum alloy and is bolted to the left (in the direction of the vehicle's movement) side of the engine. The...

Clutch design and operating principle
1. All models equipped with a manual transmission use a single-plate dry clutch with a diaphragm spring. The hub of the friction (driven) disk is equipped with...

Removal and installation the clutch master cylinder
1. The clutch master cylinder is mounted on the rear bulkhead of the engine compartment. 2. Remove the clutch pedal ( see Section 5 ). 3. Bring the brake fluid...

Removal and installation the clutch cylinder with release bearing
Caution: Remember that dust generated during wear of the clutch slave disk friction linings may contain asbestos, which is harmful to health. Do not blow off...

Bleeding air from the clutch hydraulic circuit
Warning: Brake fluid used as a working fluid in the clutch drive path is toxic and chemically aggressive and destroys the paintwork when in contact with body...

Removal and installation the clutch pedal
1. The clutch pedal is secured to a support bracket mounted on the front wall of the passenger compartment under the instrument panel. It is removed together...

Removal, inspection and installation of clutch components
Caution: Remember that dust generated during wear of the clutch slave disk friction linings may contain asbestos, which is harmful to health. Do not blow off...

Features of removal and installation of the Easytronic clutch system
19. These models require the installation of an additional device KM-6289 to prevent the clutch discs from turning (see accompanying illustration). Before...

Removal and installation the Easytronic clutch control module
1. Remove the Easytronic transmission brake fluid reservoir cap. 2. Disconnect the connector of the supply wiring harness (see accompanying illustration). 7.2....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: