Electrical equipment and devices of the car Opel Corsa B
Onboard Electrical Specifications General information System type - 12V negative ground Fuses and relays Color identification of fuses by rated current Red 10A Blue 15A Yellow 20A Green 30A...
General information and precautions Before you start servicing the components of the onboard electrical equipment, read the requirements of the safety regulations for working with electrical...
Fuses — general information Various combinations of fuses, circuit breakers and fuse links can be used to protect the contact circuits of the vehicle's electrical equipment. On the car...
Relay — general information and function check General information To supply power or control signal to some of the electrical consumers in the vehicle (such as fuel injection components, horn, starter, fan...
Removal and installation of a horn 1. Partially detach the front bumper trim or radiator grille (see chapter Body ). 2. Disconnect the electrical wiring from the horn. 3. Remove the horn....
Anti-theft device and alarm Anti-theft device Models up to 12.1994 release The electronic anti-theft device is activated when the vehicle is locked with the key or remote switch. The...
Removal and installation of a combination of devices On models from 09.1996, issue. an electronic speedometer with a speed sensor is installed. The shaft of a speedometer on these models is absent. 1. Turn out...
Removal and installation of the steering column switch The windshield wiper and outdoor lighting switches are made in the form of steering column switches. 1. Disconnect the negative cable from the battery. 2. Turn...
Removal and installation of the alarm switch 1. Install the hazard switch and mark the position «ON». 2. Carefully pry off the switch with a small screwdriver and remove it. Removing the Hazard Switch 3....
Installing the radio 1. Before installation, check the operation of the radio. 2. Disconnect the negative cable from the battery.. 3. Remove the plug from the radio shaft. 4....
Removing and installing speakers The procedure for installing the speakers is in the reverse order of the procedure for removing them. Woofer in front door 1. Loosen the fixing screws and use...
Antenna Installation The standard antenna is installed at the rear of the roof. The antenna is maintenance free and can be removed. To install the antenna in the roof there is a...
Removal and installation of the front wiper motor 1. Remove the wiper. 2. Mark with a felt-tip pen the position of the wiper rods and the crank relative to the e/motor axis. 3. Disconnect the drive mechanism...
Removal and installation of the rear wiper motor 1. Mark the position of the wiper blade on the glass with adhesive tape for later installation. 2. Fold away a protective cover of the lever of a back screen...
Check K/L of low level of a brake liquid 1. Turn on the ignition and release the parking brake. 2. Disconnect the connector from the brake fluid reservoir cap. 3. Close the connector contacts....