Exterior (external elements) of the car Opel Corsa B

Body specifications
Weight and dimensions characteristics All figures are approximate and may vary depending on the model. For more information, please refer to the manufacturer's...

General information and precautions
The body of the vehicles considered in this Manual has a universal design, the supporting element of which is the floor panel, equipped with front and rear...

Car body and underbody components care
It should be remembered that the main factor determining the resale value of a used car is the condition of its body. Body panel maintenance procedures are...

Repair of minor damage to body panels
If you cannot access the back of the body panel to tap out the dent, you should pull it out using a sliding hammer. In the deepest part of the dent, or along...

Repair of seriously damaged body panels
Such repairs are usually performed using welding equipment and must be carried out in a car service workshop. In case of extensive damage, the first thing to...

Maintenance of car hinges and locks
Every 15,000 km, or once a year, the hinges and assemblies of the door, hood and trunk lid lock latches should be lubricated with a few drops of liquid oil or...

Replacement of windshield and other fixed glass
Replacing a windshield or other fixed glass on a vehicle requires one of the special quick-setting adhesive or sealant compounds. In addition, this work cannot...

Removal and installation the bumper trim and support beam
Front bumper Models produced before 02.1997 1. Remove the two bolts (1) near the air intake. Front bumper trim mounting bolts 3. Remove the three bolts (2)...

Removal and installation the decorative radiator grille (models from 03.1997)
1. Remove the bolts securing the decorative radiator grille and front bumper trim (refer to fragment I). Procedure for removing the decorative radiator grille...

Removal and installation the wheel arch liner
1. Loosen the front wheel mounting bolts, jack up the front of the car and place it on supports. Remove the front wheel. 2. Remove the plastic nuts from the...

Removal and installation the windshield fairing panel
1. Remove the windshield wiper arms (see Chapter On-board electrical equipment ). 2. Unscrew the bolts (1) and remove the two-piece fairing. Fairing mounting...

Removal and installation the hood
You will need an assistant to remove the hood. 1. Open and lock it in the fully open position with the stop bar. 2. Disconnect the hose from the windshield...

Replacing hood hinges
1. Remove the windshield fairing panel. 2. Remove the hood. 3. To remove the right hinge, remove the battery. 4. To remove the left hinge, remove the...

Removal and installation the front wing
Removal 1. Remove the front bumper cover (see section Removal and installation the bumper trim and support beam ). 2. Knock out the rivet core (1) with a...

Replacing the rear wheel arch lining (Corsa and Combo models)
1. Loosen the plastic nuts that secure the trim from the inside of the arch. There should be 6 nuts on the Corsa, 5 nuts on the GSi, and 8 nuts on the Combo....

Removal and installation the outside mirror and its drive electric motor
Removal 1. Press the mirror out of the housing with a wide spatula. To avoid damaging the mirror housing, place a rag or cardboard underneath. The mirror can...

Removal and installation the exterior mirror housing
There are two different right mirror housings that can be supplied as a spare part, the individual elements of which are not interchangeable. Therefore, when...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: