Drive Shaft Specifications Drive shafts Type - Open, unequal length, with CV joints at both ends Type of CV joint lubrication - special grease Opel-1941522 Type of CV joints - double...
General information about drive shafts 1. From the side gears of the differential, the torque developed by the engine is transmitted to the front (leading) wheels by means of two drive shafts of...
Removal and installation of the hub nut 1. Engage the manual transmission in neutral / move the AT selector lever to the position «N». Engage the parking brake lever. 2. Remove the corresponding...
Removal and installation of power shafts Removing Attention: When pulling the CV joint pin of the drive shaft from the corresponding spline connection, the shaft must be pulled by the joint assembly -...
Right drive shaft with intermediate shaft (diesel) 1. The intermediate shaft is designed to reduce the length of the right drive shaft, thereby eliminating the possibility of torsional vibrations of the shaft...
Double Compensation CV Joint Replacement Note: Damaged hinges are only replaced as a set. 5. To replace the joint, the drive shaft must be disassembled. 6. Remove the drive shaft ( see Section 3 ) and...
Replacement of anthers SHRUS 1. To replace the boot, remove the corresponding hinge ( see Section 5 ). On vehicles with high mileage, if one boot is damaged, it is recommended to replace...
Vibration damper (right drive shaft) 1. On some models that are not equipped with an intermediate shaft, a special damper is installed on the shaft to dampen the torsional vibrations of the right...