Exterior (external body elements) Opel Corsa C (petrol)

Features of the car body design
The body of Opel cars is a load-bearing four-door, consisting of a frame and hanging elements. The body frame includes the base, sidewalls, roof and frame...

Removal and installation the front bumper
Removal Loosen the outer contour trim of the front left and right wheel arch, unscrew nut 1. Pull out and secure the outer wheel arch liner slightly. Loosen...

Removal and installation the front beam holder (impact limiter)
Removal Remove the front beam (impact limiter). Remove the front beam holder (impact limiter). Remove 2 screws. Attention! When replacing the shock limiter,...

Wing replacement — removal and installation
Removal Remove the inner wing protective covering 1. Remove the front bumper. Remove the side turn signal. Remove the wing. Fit the wing to the adjacent parts....

Removal and installation the protective sheathing inside the wing
Removal Remove the protective lining. Remove the inner part of the wing. Installation Install protective lining. Install the inner wing.

Removal and installation the rear bumper — removal and installation
Removal Open the rear hatch. Loosen the top of the rear bumper. Loosen the lower part of the rear bumper. Loosen the outer contour trim of the wheel arch on...

Removal and installation the entrance molding
Removal Using a puller, remove the five clamps from the bottom. Remove the expansion rivets. Note: The rivets are located behind the front wheel arch outer...

Removal and installation the front protective strip
Removal Remove the front protective strip. Note: To avoid damaging the paintwork when removing the protective strip, use a plastic wedge. Install a plastic...

Removal and installation the water repellent
Removal Remove the engine compartment cover 4. Remove the wiper arms 1. Unscrew the water repellent fastening screw 2 (arrows). Remove the injector hose 3....

Replacing the additional roof frame seal
Removal Remove the additional roof frame seal. Remove the additional seal from the guide. Installation Install additional seal. Insert additional seal into the...

Removal and installation the hood — removing and installing
Removal Remove the hood. When replacing the hinge: remove the water repellent. Remove the body electronic control module relay box cover. Installation When...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: