Electrical Equipment and Appliances Opel Corsa C (petrol)

General information about the electrical system
Opel cars have an electrical system with a working voltage of 12 V. The electrical equipment is made according to a single-wire scheme - the negative terminals...

Rechargeable battery
The vehicle covered in this manual has a 12-volt electrical system. The body ground is connected to the negative terminal of the battery. The battery is...

Generator — General Information
General information The generator is the source of the car's power supply. When the engine is running, it supplies all units with electricity and charges the...

Removal and installation of the generator (engine Z18XE, with air conditioning)
Removal 1. Open the hood. 2. Disconnect the battery terminals. Note: On vehicles from 2004 onwards with stability control, the steering wheel angle sensor...

Replacing the Generator Drive Pulley — Removal and Installation
Removal Remove the generator. Secure the generator in a vice Remove the generator drive pulley. Release the drive pulley cover from the snap-on fasteners. Hold...

Generator Regulator Replacement (Z18XE Engine, with Air Conditioning)
Removal Open the hood. Disconnect the battery terminals. Note: On vehicles from 2004 onwards with stability control, the steering wheel angle sensor loses its...

Checking the generator
Note: The table below provides an overview of the generator testing process.

Starter replacement (Z10XE, Z10XEP, without air conditioning)
Note: On cars from year 04 with ESP - after each battery disconnection the steering wheel angle sensor loses its basic setting. It needs to be recalibrated....

Removal and installation of the starter (Z14XE, Z16YNG, with air conditioning)
Open the hood. Note: On cars from year 04 with ESP - after each battery disconnection the steering wheel angle sensor loses its basic setting. It needs to be...

Windshield Wiper Arm Replacement
Removal Release the windshield wiper arm fasteners. Pry up and remove the protective cap. Unscrew the fastening nut. Install the KM-6626-10 puller. Remove the...

Removal and installation the window lift switch
Removal Remove the switch. Carefully pry and remove the switch from the door trim. Unlock and disconnect the wiring harness connector. Installation Install the...

Removal and installation the rear wiper motor
Removal Remove the windshield wiper arm and unscrew the mounting nut. Remove the rear hatch inner trim. Remove the windshield wiper motor. Unlock and...

Replacing both wiper arm bearings
Removal Remove the water drain shield. Remove the front wiper motor. Unlock and disconnect the front wiper motor wiring harness connector. Remove the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: