Car rear suspension Opel Corsa B

Removal and installation the rear shock absorber
Corsa B and Tigra models Based on the design of the suspension, you should remove only one shock absorber first, and then the other. Removal 1. Remove the...

Removal and installation the rear suspension spring (Corsa and Tigra models)
1. Jack up the car and place it on supports. 2. Jack up the right rear shock absorber support 3. Unscrew the lower bolt securing the right shock absorber and...

Removal and installation the anti-roll bar (Corsa and Tigra models)
Removal 1. Mark the position of the rear wheel relative to its hub so that the balanced wheel can be installed in its original position. Loosen the wheel...

Removal and installation the wheel bearing
The wheel bearing on the Opel Combo is located in a separate wheel hub, while on other models it is located directly in the brake drum. In addition, the wheel...

Adjusting the clearance in the wheel bearing
1. Jack up the rear of the vehicle to free the corresponding wheel. 2. Carefully remove the wheel cover with a screwdriver. 3. Pull out the cotter pin of the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: