Car clutch and drive shafts Opel Corsa B

Clutch and Drive Shaft Specifications
Clutch Type - Single-disc, dry, with diaphragm spring and hydraulic drive Drive shafts Type - Open, unequal length, open type, with constant velocity joints at...

General information about clutches and drive shafts
This Chapter is devoted to the transmission components located between the rear of the engine and the drive wheels of the vehicle (excluding the gearbox, which...

Design of the clutch and its drive components
All models equipped with a manual transmission use a single-plate dry clutch with a diaphragm spring. The hub of the friction (driven) disk is equipped with...

Removal and installation the clutch
To remove the clutch, you will need a special tool. Clutch on 1.2 and 1.4 l engines can be removed and installed with a manual transmission installed. On cars...

Removal, checking and installation the clutch release bearing
Removal 1. Remove the clutch. 2. Disconnect the clutch fork from the clutch release bearing and remove the bearing. Disconnecting the clutch fork from the...

Replacing the clutch cable
Since 09.1995, design changes have been made to the clutch drive cable, the cable guide to the pedals and the damping element at the clutch rocker arm. 1. If...

Checking the condition of clutch components
Remember that dust generated during wear of the clutch slave disk friction linings may contain asbestos, which is harmful to health. Do not blow off dust with...

Drive shafts — general information
From the side gears of the differential, the torque developed by the engine is transmitted to the front (driving) wheels via two drive shafts of unequal...

Removal and installation drive shafts
Removal 1. Set the parking brake. 2. Remove the wheel disc cover. Remove the locking pin of the crown hub nut and loosen the nut. In this case, the car must be...

Checking the condition and replacing constant velocity joints (CV joints)
Examination During a test drive on a limited-size area, try to determine the condition of the outer CV joints by ear. A worn joint makes a characteristic...

Replacement of protective covers of CV joints
On models with internal tripod type hinges, replacing their protective covers is only possible after removing the external hinges. 1. Remove the drive shaft...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: