Car clutch repair Opel Omega A

Clutch specifications
For later model years, see the Appendix at the end of the Manual ( Section 13 ). General information Clutch type - Single-disc, pressure plate with diaphragm...

General description
All models with manual transmission have a single-plate clutch with a diaphragm spring. The clutch housing is bolted to the rear surface of the flywheel. The...

Routine maintenance
1. Perform the following procedure at the frequency given in Section " Maintenance " at the beginning of this Guide. Checking the clutch pedal adjustment 2....

Clutch cable — removal and installation
1. Apply the handbrake. Jack up the front of the car and secure it on axle stands. 2. Using a steel ruler, measure the distance from the lock nut to the end of...

Clutch pedal — removal and installation
1. Disconnect the clutch cable from the pedal as described in Chapter 3 . 2. From inside the vehicle, disconnect the electrical wiring from the brake light...

Clutch — removal
1. Remove the gearbox as described in Section 6. 2. Mark the clutch housing relative to the flywheel (photo). 3. Loosen the bolts securing the clutch housing...

Clutch — inspection
1. Check the surface condition of the pressure plate and flywheel. If necessary, replace the pressure plate and flywheel. 2. If the pressure plate has blue...

Release bearing and lever — removal and installation
1. With the gearbox removed to provide access to the clutch, you can check the release bearing located in the clutch housing (photo). 2. Remove the rubber...

Clutch — installation
1. Wipe the surfaces of the pressure plate and flywheel with a clean cloth. When installing, be careful not to allow oil or grease to come into contact with...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: