Car care Car wash Environmental protection laws prohibit car washing in non-designated locations. If the car is often washed in automatic car washes, the rotating...
Starting the engine using a booster battery Precautionary measures If the prescribed procedure is not followed, there is a risk of burns from acid escaping from the battery. In addition, there is a risk...
Towing a car The tow rope must only be attached to the tow hooks installed on the vehicle. 1. Remove the trim covering the hole for the tow hook on the front bumper (see...
Poddomkrachivanie car When working under a vehicle, it must be positioned and securely secured to jack stands if it is not on a lift. If the car is jacked up, then in this case, you...
Maintenance plan Vehicle maintenance work should be carried out at the following intervals: 2.5L Diesel Vehicles - Engine Oil Change On vehicles with a 2.5 liter diesel engine,...
Maintenance — work This chapter discusses all the maintenance work of various systems, components and assemblies of the car, which must be performed as part of the maintenance...
Fuel filter — condensate removal/replacement Condensate removal Special tools and fixtures are not required. Necessary parts to replace worn ones: fuel filter corresponding to the type of engine, filter...
V-belt — check Special tools and fixtures are not required. Attention! The length of the ribbed accessory drive belt depends on the engine type. This should be taken into...
Timing belt of the gas distribution mechanism — check Attention! The procedure for replacing the timing belt is indicated in the corresponding chapter. 1. Inspect the timing belt for damage or wear. 2. Check the...
Coolant — check Checking the coolant level The coolant level should be checked regularly, approximately every 4 weeks and at least before any long trip. To replenish the...
Coolant — Concentration Check To avoid the occurrence of malfunctions, it is recommended to check the coolant concentration regularly, and especially before the onset of the winter period...
Exhaust system — visual leak test 1. Jack up the vehicle and place it on jack stands. 2. Check up firmness of landing of collars of fastening of system of release. 3. Inspect the pipes of the...
Air Filter Replacement Element — Replacement Special tools and fixtures are not required. Necessary materials: replaceable filter element. Removing 1. Disconnect the hose from the air filter housing. 2....
Spark plugs — removal, inspection and installation Required tools and fixtures: candle wrench 16 mm, for example, HAZET900AKF. Necessary materials: 4 or 6 spark plugs according to specification. 1. Unscrew the...
Gearbox and final drive The following maintenance work must be carried out: Vehicles with manual and automatic transmission. Check visually for leaks. If there are leaks, contact the...
Brakes. Tires. wheels In accordance with the maintenance plan, the following work must be carried out: Checking the thickness of the brake pads of the front and rear wheels....
Brake Fluid — Level Check The brake fluid expansion tank is located in the engine compartment and consists of two chambers, one for each of the brake circuits. The tank is made of...
Brake Fluid — Change Required tools: overhead wrench 9 mm for unscrewing the fitting for bleeding the hydraulic drive of the brake mechanism, transparent hose, container for...
Wheels and tires Depending on the model and equipment, OPEL OMEGA vehicles can be equipped with tubeless radial tires and different wheel sizes. When installing tires or wheels...
Front axle and steering In accordance with the maintenance plan, the following work must be performed on this unit: Tie rod ends. Check the presence of play, the condition of the...
Body. Salon equipment In accordance with the maintenance plan, the following work must be carried out: Lubricate the tailgate hinges. Lubricate the door opening limiters, door...