The power supply system consists of a fuel tank, a fuel pump, a filter and connecting pipes. Take precautions when handling gasoline.
Specifications System type: - 2.0L SOHC engine Bosch Motronic M1.5.4 – 2.0L DOHC engine Simtec 56.1 or 56.5 – engines of 2.5 and 3.0 liters Bosch Motronic M2.8.1 or M2.8.3...
Unleaded gasoline The recommended type of gasoline is unleaded gasoline with an octane rating of RON 95, it is also possible to use gasoline with an octane rating of RON 91 or...
Fuel injection systems Models with 2.0L sohc engine - bosch motronic m1.5.4 Engine Control Locations - 2.0L SOHC Engine 1. Idle speed control valve 2. Throttle Potentiometer 3. Purge...
Air filter and air pipes Removing To remove the air filter cover, disconnect the air pipes and release the mounting clip. To remove the air pipes, release the mounting clamps....
Accelerator cable — removal and installation Removing 1. Release the retaining clip and disconnect the cable from the throttle lever. 2. Remove the cable sheath from the mounting bracket. 3. Release the...
Accelerator pedal — removal and installation Removing 1. Remove trim panel and air tube. 2. Disconnect the cable from the accelerator pedal. 3. Loosen the fixing nuts (shown by arrows) and remove the...
Releasing pressure from the fuel injection system Pressure Release Valve Location on 2.0L DOHC Engines The valve is located on top of the fuel manifold. The location of the pressure release valve on engines of...
Fuel pump — removal and installation Removing 1. Release pressure from the supply system. 2. Unfold the carpet in the luggage compartment, unscrew the fixing screws (indicated by arrows) and...
Fuel level sensor — removal and installation Removing Remove the fuel pump cover, release the mounting clip and remove the sensor. Installation Installation is carried out in the reverse order of removal.
Fuel tank — removal and installation Removing 1. Release pressure from the supply system. 2. Remove the rear right wheel housing insert. Sedan Models 3. Disconnect the fuel pump connector (1) (2 –...
Throttle body Models with 2.0L sohc engine Removing 1. Disconnect the negative battery cable. 2. Disconnect the air pipe from the throttle body and air filter and remove the...
Fuel injection system (2.0 liter engine) Fuel injectors Removal and installation SOHC engine 1. Release pressure from the power system and disconnect the negative battery cable. 2. Remove the fuel...
Fuel injection system (engine 2.5 and 3.0 liters) Fuel injectors Removal and installation 1. Remove the lower section of the intake manifold. 2. Disconnect the connectors from the injectors. 3. Remove the...
Inlet manifold — removal and installation 2.0L sohc engine Removing 1. Release pressure from the power system and disconnect the negative battery cable. 2. Remove the drive belt and drain the coolant....
Exhaust manifold — removal and installation 2.0L sohc engine Removing 1. Unscrew the fixing bolts of the exhaust pipe of the exhaust system and disconnect the exhaust pipe. 2. Remove the heat shield. 3....
Multi-flow air supply system This system serves to increase engine power at any engine speed. The system consists of a pre-chamber and two dampers, one of which is installed in the air...
Exhaust gas exhaust system On models with a 2.0L engine, the exhaust system consists of three sections: front pipe with catalytic converter, intermediate pipe and muffler, exhaust pipe...