Car steering Opel Omega A

Steering Specifications
For later model years, see Appendix at the end of the Manual (Section 13). Type - Worm shaft with pendulum and amplifier Ratio - 14.5:1 Lubricant type - Dexron...

General description
All models are equipped with power steering. The steering is of the worm type. On fuel-injected models, the hydraulic system has a pressure sensor (photo). It...

Steering wheel — removal and installation
1. Disconnect the negative battery cable. 2. Set the front wheels straight ahead. 3. Use a lever to remove the horn button from the center of the steering...

Steering column — removal and installation
1. Disconnect the negative battery cable. 2. Inside the vehicle, mark the position of the inner column relative to the pivot joint, then loosen and remove the...

Steering column (without height adjustment) — bulkhead
Note: Replacing the upper bearing can be accomplished without removing the entire column, however it must be removed to replace the lower bushing. 1. Remove...

Steering column (with height adjustment) — bulkhead
Note: Replacing the upper bearing can be accomplished without removing the entire column, however it must be removed to replace the lower bushing. 1. Remove...

Steering gear — removal and installation
1. Working inside the vehicle, lift the trim near the pedals, then loosen and remove the steering column pivot clamp bolt. 2. Place a container under the...

Steering gear — adjustment on site
1. The steering gear can be pre-adjusted on the vehicle on site. First, jack up the front of the vehicle and secure it on axle stands. 2. Loosen the nut...

Steering rods — removal and installation
1. Apply the handbrake, jack up the front of the car and secure it on axle stands. Remove the front wheels. 2. To remove the tie rod, unscrew the nuts and,...

Steering idler gear — removal and installation
1. Apply the handbrake, jack up the front of the car and secure it on axle stands. Remove the left wheel. 2. Disconnect the center tie rod by unscrewing the...

Power Steering Pump — Removal and Installation
1. Loosen the two pivot bolts on the top of the pump. 2. Loosen the tensioner nut and bolt under the pump and the inner nut of the adjusting rod. 3. Loosen the...

Wheel installation — checking and adjustment
1. Accurate wheel alignment significantly affects steering efficiency and prevents excessive tire wear. Before checking, make sure the vehicle is not...

Wheels and tires — care and maintenance
Wheels and tires should not cause any real problems during operation if regularly inspected and maintained. Check your tire pressure regularly. Checking should...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: