Repair of car engines, where a six-cylinder two-row engine with water cooling and two camshafts in each head is installed.
Specifications engine's type Six-cylinder, two-row, water-cooled and two camshafts in each head 2.5L engine 3.0L engine Engine code X25XE X30XE Cylinder diameter 81.6 mm 86.0...
Compression test If the engine runs poorly or intermittently, check the ignition system and fuel system. If the cause of poor engine performance could not be found, perform a...
Top dead center (TDC) piston No. 1 Top dead center is the highest point reached by piston N1 during the compression stroke. Piston N1 is located in front of the right bank of cylinders on the...
Camshaft covers Removing 1. Remove the intake manifold. Right cover 2. Remove the spark plug caps and disconnect the high voltage wires. 3. Remove the camshaft cover bolts. 4....
Crankshaft pulley Removing 1. Remove the auxiliary drive belt. 2. Turn the crankshaft so that the mark on the pulley is aligned with the pointer on the timing belt cover. 3....
Timing belt covers Outer cover Removing 1. Remove the pre-chamber of the multi-flow air intake system (see subsection 5.1.15 ). 2. Remove the front connecting tube of the...
Gas distribution belt Timing belt adjustment tools 1. KM-800-20 2. KM-800-1 3. KM-800-30 4. KM-800-10 5. KM-800-2 To adjust the timing belt, you will need the following special...
Belt tensioner, sprockets and intermediate pulleys Camshaft sprockets Camshaft sprocket right cylinder head The exhaust valve shaft locating pin must fit into slot 1, and the intake valve shaft stud into slot...
Camshaft seals — replacement 1. Remove the camshaft sprocket. 2. Drill two small holes in the old oil seal. 3. Screw in the screws and remove the seal. 4. Clean the gland groove and remove...
Camshafts and tappets Removing 1. Remove the camshaft cover. 2. Remove the camshaft sprockets. If you are removing the right cylinder head camshafts, turn them back approximately...
Cylinder head Cylinder head bolt tightening sequence Removing 1. Remove the battery. 2. Remove the windshield wiper arms and reflective panel. 3. Remove the intake manifold....
Oil pan Sealing locations Removing Pallet 1. Disconnect the negative battery cable. 2. Raise and secure the front of the vehicle. 3. Drain the engine oil. 4....
Oil radiator Removing 1. Drain the coolant. 2. Remove the intake manifold. 3. Disconnect the wires from the engine coolant temperature indicator sensor and engine...
Flywheel and drive disc Removing Manual Transmission 1. Remove the gearbox and clutch. 2. Stop the flywheel and mark its correct installation location. 3. Unscrew the bolts and remove...
Crankshaft seals Front crankshaft oil seal 1. Remove the crankshaft sprocket. 2. Drill two holes in the gland, screw the screws into them and remove the gland. 3. Thoroughly...
Engine and gearbox mounts Examination 1. Raise and secure the front of the vehicle. 2. Inspect the rubber mounts for wear and damage and replace if necessary. 3. Check that the support...