General description Engine: 4-cylinder overhead camshaft, and designed based on a series of gasoline engines. The head and cylinder block are cast iron. The crankshaft rotates in...
Compression test — description 1. If the engine power drops, the cause of which is not due to a malfunction in the fuel system, a compression test will determine the condition of the engine....
The main actions possible with the engine in the car a) Removal and installation of a head of the block of cylinders. b) Removal and installation of the pallet. c) Removal and installation of the oil pump. d)...
Engine removal method The engine can be removed with a strong winch separately and together with the transmission. The block is removed from the engine compartment upwards.
Engine — removal 1. Park the vehicle on level ground, block the rear wheels, apply the handbrake. Jack up the front of the vehicle and support it securely on axle stands....
Engine Disassembly — General Description 1. The engine must be disassembled in a clean area free from dust and dirt. 2. It is advisable to prepare suitable containers for storing small parts, this...
Auxiliary parts of the engine — removal 1. Although the listed items can be removed separately from the installed engine, it is best to remove them after the engine has been removed from the vehicle,...
Engine — complete disassembly 1. Remove the accessories listed in Chapter 8. 2. Unscrew and remove the oil pressure sensor. Remove the oil level dipstick. 3. Disconnect the crankcase...
Engine mounting brackets — replacement 1. Apply the handbrake. Jack up the front of the car and support it on axle stands. 2. Remove the nuts from the top of both engine mount brackets, remove the...
Valve clearances — checking and adjusting General information To compensate for the thermal expansion of the valves, there is a gap in the valve mechanism, which must be correctly set. If the gap is...
Engine Components — Inspection and Rebuild Oil pump 1. See Section 1A, Chapter 14 . Crankshaft 2. See Section 1A, Chapter 14 . Main and connecting rod bearings 3. See Section 1A, Chapter 14 . Cylinder...
Cylinder head — bulkhead Note: To minimize wear, it is essential that the rocker arms, valve lifters, valves and related components be installed in their original positions. 1. From...
Engine — Assembly Note: Use new flywheel/drive plate mounting bolts and cylinder head mounting bolts. 1. Turn over the block of cylinders, wipe saddles of loose leaves of...
Engine — Installation Engine installation is carried out in the reverse order to the removal of the sequence given in Chapter 6 , but in addition, note the following points: a)...