Car driveshaft Opel Omega A

Propeller shaft specifications
For later model years, see the Appendix at the end of the Manual ( Section 13 ). Type - Double tubular shaft with center bearing, center universal joint and...

General description
The twin-tube driveshaft has a central bearing supported in a rubber boot. The tail section has a universal joint at the front end and the front section has a...

Cardan shaft — removal and installation
1. Block the front wheels. Jack up the rear of the car and secure it on axle stands. 2. On models equipped with a catalytic converter, remove the mounting...

Central bearing — replacement
1. Remove the driveshaft as described in Chapter 2. 2. Clamp the rear of the driveshaft in a vice. 3. Mark the front and back pieces relative to each other,...

Coupling discs — replacement
1. Block the front wheels. Jack up the rear of the car and secure it on axle stands. 2. Apply the handbrake, then loosen only the slider clamp nut on the front...

Final Drive Rear Cover Gasket — Replacement
1. Remove the damper suspension as described in Chapter 4 . 2. Place a suitable container under the final drive mechanism, then unscrew and remove the cover....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

See similar ones from other Opel car manuals:
▶ Transmission: Cardan shafts Opel Frontera A (1991-1998, petrol)

Share information: