Cardan drive shafts Opel Frontera A (petrol)

Cardan shaft and final drive specifications
Note: Individual characteristics are also given in the text of the Chapter and, if their implementation is mandatory, are highlighted in bold. Cardan shaft...

Front wheel drive
When carrying out all the described work, the car must be raised at the front and securely fastened. The front wheels must be removed (mark the position of the...

Removal and installation the front wheel hub
Removing the wheel hub requires a large wrench to loosen the wheel nut. 1. Remove both caliper mounting bolts shown in the illustration. 2. Tie it to the...

Front propeller shaft — removal and installation
Important note: The bolts securing the propeller shaft to the main gear flange are self-locking and are not used a second time. 1. Place the front of the...

Removal and installation front wheel drive shafts
1. Remove the shaft. 2. Remove the four bolts securing the front axle bracket. 3. Remove the drive unit from the bridge. 4. Collect the leaking liquid in a...

Replacement of the constant velocity joint boot
When replacing the cover, it is necessary to introduce the specified amount of consistent grease into the hinges. 1. Unscrew the two bolts. 2. Remove the brake...

Automatic hub lock
Frontera Sport and its modifications are equipped with manually controlled freewheel hubs. Limousines are equipped with automatic freewheel hubs. Both versions...

Manual hub lock
1. Set the gear selector lever to the "2H" position. 2. Turn the freewheel hub to the "FREE" position. 3. Remove six bolts. 4. Remove the housing and coupling....

Rear Wheel Drive — General Information
Two different cardan shafts are used to drive the rear axle. Three-door cars have a solid propeller shaft. For vehicles with an extended base (5 doors), a...

Fixing rear axle leaks
Axle shaft seals The seals are part of the drive bearing. The bearing is lubricated at the factory and does not require maintenance. If traces of grease are...

Removal and installation rear axle shafts
1. Open the brake fluid reservoir. 2. Place plastic over the hole 3. Close the tank again. This prevents fluid from leaking out when the brake system is...

Replacing the rear axle bearing
Drum brakes To replace a bearing you need to have a press. 1. Clamp the axle shaft in a vice. 2. Use a chisel to cut off the bearing retaining ring. Use...

Removal and installation the rear propeller shaft
Solid cardan shaft Removal of the solid propeller shaft is carried out in the same way as removal of the front propeller shaft, described in the section...

Differential — disassembly and assembly
Disassembly, adjustment and assembly of the differential requires the use of a special tool. Therefore, a description of this operation is not given here,...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

See similar ones from other Opel car manuals:
▶ Transmission: Cardan shaft Opel Omega A (1986-1993)

Share information: