Engine lubrication system Opel Frontera A (petrol)

Engine lubrication system — general information
The engine lubrication system supplies the engine with lubricating oil during operation. The lubrication system consists of an oil pump, oil pan, pressure...

Oil pan — removal and installation (2.0L engine, before 1997)
Removal The oil pan can be removed without removing the engine, if, for example, it is necessary to replace the crankcase gasket. The work is quite...

Oil pump — removal and installation (2.0L engine, before 1997)
1. Remove the timing belt and rear belt cover. The piston of the first cylinder must be at TDC. Read the relevant instructions. The timing belt cover has two...

Oil pump repair (2.0L engine)
The oil pump is gear-type, with internal gears. The pump has a pressure reducing valve. To remove the valve, unscrew the plug. Caution! The plug is under...

Oil pan — removal and installation (2.0L engine, since 1997)
View of the so-called supporting oil pan for an engine produced since 1997. The arrows show the places where sealant is applied to the groove of the rear base...

Oil pump — removal and installation (2.0L engine, since 1997)
The installation and removal of the oil pump is performed in the same way as for engines manufactured before 1997. The difference is in the removal of the oil...

Oil pan — removal and installation (2.4L engine)
When removing and installing the oil pan, in addition to the cross member, both engine mounts must be removed from the chassis. The engine must be lifted with...

Oil pump — removal and installation (2.4L engine)
Removal and installation of the oil pump is carried out in the same way as for 2.0 l engine produced before 1997 . The difference is that you don't need to...

Oil pump repair (2.4L engine)
Despite the difference in the design of the gears, in this case the instructions given above apply to repairs. The 2.4L engine oil pump uses spur gears. 1. To...

Oil filter — removal and installation
The filter is located at the bottom of the oil pump. The filter is a replaceable filter element. A special key is used to remove it. When installing the...

Oil radiator (if installed) — removal and installation
If the engine has an oil cooler, it is located under the front of the car. To get to the oil radiator, you need to remove the radiator grille of the cooling...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: