Car steering repair Opel Ascona C

Steering — Specifications
Type - Rack and pinion mechanism with safety column. Some models have power steering. Manual steering Coefficient: Models with manual transmission 1.3 — 22.0:1...

General description
The steering is of the rack and pinion type, whereby the motion is transmitted to the front wheels via tie rods that are connected to the rack via a sliding...

Routine Maintenance — Steering
1. Regularly inspect the flexible bellows on the steering rack housing and the ball joint housings at the ends of the rods for cracks and damage. If necessary,...

Rod End Cap — Removal and Installation
1. Raise the front of the car and remove the wheel. 2. Loosen the tie rod end joint nut, release the stud using the ball joint release tool, and remove the nut...

Steering — removal and installation
Steering without power assistance. 1. Remove the air conditioner. 2. If you have a headlight cleaning system installed, release the fluid reservoir and move it...

Steering rack bellows — replacement
1. To replace a faulty bellows, first carefully remove the steering gear as described in the previous Section. 2. Remove the mounting bracket and its rubber...

Steering — inspection
Manual steering. 1. Remove the steering from the vehicle as described earlier. 2. Clean off external dirt. 3. Remove the bellows and the case cuff. 4. Remove...

Steering wheel air freshener — removal and installation.
1. Some models are equipped with a steering shock absorber, which is installed between the rack and the rack housing. 2. First unscrew the shock absorber from...

Steering wheel — removal and installation
1. Disconnect the negative battery cable. 2. Remove the horn button from the center of the steering wheel and disconnect the wires. Photo 8.2 The horn button...

Steering column — removal and installation
1. Disconnect the battery ground cable. Remove the four screws and remove both halves of the steering column cover. 2. Disengage the direction indicator and...

Steering column — inspection
Please note: The steering column can be disassembled and assembled either while it is installed on the vehicle or while it is removed; the procedure remains...

Steering column lock — removal and installation
1. To replace either the ignition switch or the steering lock cylinder, first remove the lower half of the steering column cover by unscrewing and removing the...

Steering Angles and Wheel Layout — General Description
1. Correct alignment of the front wheels is essential for good steering performance and even tire wear. Before tackling the corners, check that the tires are...

Power Steering — Blowing Out
1. Fill the pump fluid reservoir to the top with the specified liquid. 2. Start the engine and let it idle. 3. Slowly turn the steering wheel from one extreme...

Power Steering Pump Drive Belt — Tensioning
1. The belt must be tensioned in the same way as the generator drive belt, as described in Chapter 2 . 2. Before making any adjustments, loosen the mounting...

Fault Diagnosis — Steering
Symptom/ Cause/s/. The steering wheel loses movement/ The rack and pinion mechanism is worn out. The ball joints at the ends of the rods are worn out....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: