Brake system — general information The brake system of the Frontera has been completely redesigned since mid-1995. As a result, the description of the braking system is divided into two parts....
Brake Specifications Note. Separate characteristics are also given in the text of the Chapter and, if they are mandatory, are highlighted in bold. Type - until mid-1995 release...
Replacing the front brake pads As already mentioned, the new generation Frontera is equipped with different disc brakes. However, this does not affect the technology of removing and...
Brake discs — removal and installation Before removing the brake disc, it must be checked for runout, as the disc may be deformed. The brake disc is attached with a Torx head bolt. However, the bolt...
Removal and installation of a back brake drum Here it is also necessary to bear in mind that the material of the brake pads contains asbestos. Removing 1. Raise and place the rear of the vehicle on stands....
Replacing the rear brake pads Brake pads are replaced in pairs, even if one of them does not appear to be defective. To be able to determine the degree of wear of the brake pads, the brake...
Rear wheel cylinder — removal and installation A repair kit is available for repairing a wheel cylinder. Compare the parts of the repair kit with the parts that were removed to eliminate reassembly errors....
Removal and installation of a back brake board To remove the brake shield, it is necessary to remove the brake drum, brake shoes and wheel cylinder. The description of these works is given in the...
Removal and installation of rear brake pads Here the calipers have the same design as on the front wheels. With the exception of the description below, other work is carried out in the same way as the...
Removal, repair and installation of the rear caliper There is a caliper repair kit. If it is missing, the caliper must be replaced. Excluding some details, the whole caliper has the appearance shown in the...
Replacement of a casing of a back brake disk Replacing the brake disc housing on the rear wheels is different from the same operation on the front wheels due to the parking brake. The work is carried out...
Replacing parking brake pads With disc brakes, the parking brake is applied by pressing the brake pads against the brake disc when the parking brake lever is actuated. Parts of the parking...
Master brake cylinder — removal and installation Removing Before removing the brake master cylinder, depress the brake pedal several times to release the vacuum in the vacuum booster. When removing the master...
Removal of air from the brake system It is necessary to remove air from the brake system if it was opened at any point or air got into the system in any other way. Before removing the air, it is...
Vacuum brake booster — removal and installation To identify possible reasons for the inefficient operation of the brake system due to defects in the vacuum booster, it is necessary to carry out the following...
Parking brake — removal, installation and adjustment Parking brake adjustment The process of adjusting the parking brake depends on the design of the service brake on the rear wheels. It is different for drum and...
Pressure regulator — removal and installation The pressure regulator cannot be repaired and, in case of defects in operation, is replaced. The correctness of the pressure regulator can be checked using a...
Brake hoses front and rear brakes Before replacing any brake hose, it is necessary to fill the reservoir with brake fluid and, as described in the last subsection, close it with polyethylene....