Body exterior of cars Opel Ascona C

Bodywork and fixtures — specifications
Type - welded steel, single piece construction Model Code - Body Type 81, 88 — *two-door Saloon 84, 89 - five-door Hatchback 86, 87 - four-door Saloon 82, 83 -...

General description
The body and chassis are a welded steel structure. Body styles include two- and four-door Saloon, five-door Hatchback, five-door Estate and two-door...

Door hinges, hood and trunk lids, locks and handles — lubrication
1. Lubricate the hinges of the hood, trunk lid and doors periodically, applying 1-2 drops of motor oil. It is best to do this immediately after the car has...

Hood — removal and installation
1. Open the hood and support it in the fully open position. 2. Mark the position of the hinges on the inside surface of the hood. 3. With the help of an...

Bonnet Lock Cable — Replacement
1. Remove the cable clamp from the top of the front cross member. 2. Using a screwdriver, disconnect the end of the cable fastening from the handle side. 3....

Grille and radiator — removal and installation
1. The grille is held in place by clamps at the top and at the bottom it is secured by tabs that fit into holes (see photo 8.1). Photo 8.1 Lower mounting...

Front bumper — removal and installation
1. The bumpers are constructed from impact-resistant plastic and are bolted directly to the body and fenders. 2. Unscrew the mounting bolts located under the...

Rear bumper — removal and installation
Saloon and Hatchback 1. Remove the license plate light bulb from the rear bumper as described in Chapter 12 , and then disconnect the electrical wire from it....

Front wing — removal and installation
1. Remove the front wheel. 2. Remove the protective cover from the wheel arch (from under the wing), after detaching its clamps and unscrewing the screws that...

Outside rear view mirror — removal and installation
1. Place a wooden or plastic wedge against the outer edge of the mirror glass and carefully pry the mirror free. Disconnect the regulator connectors and heater...

Outside rear view mirror cover (manual control) — removal and installation
1. Working from inside the vehicle, remove the mirror remote control handle cover (see photo 43.1). Photo 43.1 Remove the outside mirror handle cover... 2....

External rear view mirror cover (electric) — removal and installation
1. Remove the inner door trim panel as described in Section 12 , and disconnect the mirror wiring plug. 2. Remove the cover and loosen the three mounting...

Outside rear view mirror motor — removal and installation
Figure 11.59. Removing the mirror motor 1. Remove the mirror glass as described above. 2. Remove the inner door trim panel as described in Section 12 , and...

Rear Air Deflector (Estate) — Removal and Installation
1. Open the rear door and remove the four screws that secure the air deflector to the rear door. Figure 11.86. Rear air deflector bolts (Estate) 2. Remove the...

Rear Ventilation Grille (Estate) — Removal and Installation
1. The pillar vent grille simply snaps into the body pillar. Remove it by carefully prying the edges, being careful not to damage the paint. 2. When installing...

Electrical System — Specifications
System type: 12 Volt with negative ground. Generator with drive belt and pre-connected starter motor Battery capacity - 36 or 44 Amps Generator Type. Bosch or...

Bodywork (late models)
Rear Door Lock Parts (Estate) - Removal and Installation 1. On later models, the rear door lock components have been modified and the removal and installation...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: