Contact breaker ignition system Opel Ascona C

Ignition system — specification
Part A: Ignition System with Mechanical Contact Breaker General part Type - With battery, ignition coil and distributor driven by camshaft and mechanical...

Ignition system with mechanical contact breaker — general description
In order for the engine to operate properly, it is necessary for the spark plug to ignite the working mixture in the combustion chamber at the right time in...

Ignition System — Routine Maintenance
The following operations are performed at the intervals specified in the "Routine Maintenance" section at the beginning of this Manual. 1. Remove and carefully...

Breaker contacts — adjustment of the gap and angle of the closed state of the contacts
1. Release the clamps of the distributor cap moisture protection casing (if any) and take it off (see photo). Photo 3.1. Removing the distributor cap...

Breaker contacts — removal and installation
1. If the breaker contacts are burnt, pitted or badly worn, they should be replaced. 2. Remove the distributor cap cover, cover, runner and plastic plate...

Capacitor — removal, inspection and installation
1. The purpose of the capacitor is to ensure that there is no spark between open contacts, as this leads to unnecessary waste of voltage and premature wear of...

Distributor — removal and installation
1. Disconnect the negative battery cable. Figure 4.1. Mark for rotor installation on the distributor housing rim 2. Remove the distributor cap. Figure 4.2....

Distributor — disassembly, inspection and assembly
1. Before disassembling the distributor, check whether spare parts are available for sale. In some cases (in case of severe wear of the distributor) it may be...

Ignition timing angle — adjustment
Leaded fuel 1. The ignition must be adjusted if it was knocked down after overhauling or removing the distributor. The following procedures are designed for a...

Spark plugs and high tension wires — common part
1. Proper spark plug operation is critical to efficient engine operation. It is necessary to use only spark plugs approved for your engine ( see Specifications...

Ignition coil — common part
1. The coil is an autotransformer and has 2 windings and a core made of soft iron wire. The resistance of the primary winding is given in the Specifications at...

TDC position sensor
1. As already indicated in chapter 1 , the engine in question can be equipped with a TDC sensor 2. The crankcase has a brass bushing into which a sensor can be...

Ignition Switch — Removal and Installation
1. Disconnect the battery. 2. Loosen the screws and remove the lower cover from the upper end of the steering column. 3. Remove the 2 small screws and pull out...

Ignition system with mechanical contact breaker — troubleshooting
1. Most engine performance problems are usually caused by a faulty ignition system in one of the circuits: low or high voltage. 2. There are 2 main signs that...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: