Contactless car ignition system Opel Ascona C

Contactless ignition systems — general description
1. The models in question are equipped with two types of contactless ignition systems. On 1.3 engines (after September 1982.) the Delco AC system is installed,...

Contactless Ignition Systems (All Models) — Precautions
1. In order not to damage the components of the contactless (electronic) ignition systems, in addition to the usual precautions against electric shock, the...

Contactless Ignition Systems — Routine Maintenance
1. Follow the instructions in paragraphs 1 and 4 section 2 of this chapter, observing the precautions specified in section 15 . 2. The distributor of the...

Distributor — removal and installation
Engine 1.3 1. Remove the spark plugs. 2. Loosen the screws securing the distributor cap and remove it. 3. Put the car in gear, release the handbrake and push...

Distributor — disassembly, inspection and assembly
Engine 1.3 1. Remove the distributor from the engine ( see previous section ). 2. Unscrew the 2 mounting screws and remove the rotor. 3. Disconnect the 2...

Ignition timing — regulation
Leaded fuel 1. In case of contactless ignition system, it is impossible to check the static ignition timing angle. However, if the distributor was installed...

Ignition coil — common part
1. The ignition coil is an autotransformer with 2 windings wound on a core made of soft iron wire or plates. The coil is located on the inner surface of the...

Ignition module — removal and installation
1. On models with a 1.3L engine, the ignition module is located in the distributor (more details see section 18 ). 2. On models with 1.6/1.8L engines, the...

Ignition system (late models)
Ignition system without breaker (1.8 and 2.0 l, since 1987) — general information 1. The ignition system types installed on large displacement models from 1987...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: