Vehicle power devices Opel Ascona C

Battery — Checking and Maintenance
1. A routine weekly battery check consists of measuring the electrolyte level in each cell and ensuring that the separator plates are covered with a 5 mm layer...

Battery — Removal and Installation
1. The battery is located on a support plate attached to the left wing area in the engine compartment. Disconnect the negative battery cable, then the positive...

Battery — charging
1. In winter, when the battery is under heavy load, for example, when starting the engine from a cold state, and also when most electrical equipment is...

Generator — Precautions
1. If you suspect that the charging system is not functioning properly, you must take precautions when diagnosing faults, otherwise you may cause additional...

Generator — General Description
The vehicles described in this Manual are equipped with a Bosch or Delco-Remy type alternator; these two types have similar design and output current. The...

Generator — removal and installation
1. Disconnect the battery cables. 2. Note the position and purpose of the wires located at the rear of the generator and disconnect the plug or connector, or...

Generator — troubleshooting
Because diagnostics of a generator require specialized knowledge and equipment, it is recommended that the generator be thoroughly checked by an auto...

Generator Brushes (Delco-Remy Type) — Checking, Removing and Installing
1. Disconnect the generator from the engine as described in Section 8 . 2. Scratch a line through the stator housing and front end cover to ensure proper...

Generator brushes (Bosch type) — checking, removal and installation
1. Loosen and remove the two screws, spring washers and washers that secure the brush box to the rear of the casing. Remove the brush box and voltage regulator...

Starter Motor — General Description
The starter motor is mounted on the back of the top of the engine and can be either a Bosch or DeLco-Remy type. Both are pre-engaged, meaning the drive pinion...

Starter Motor — Checking in a Car
1. If the starter motor does not turn the engine when the ignition is turned on, there are five possible reasons for this: a) The battery is faulty; b) The...

Starter motor — removal and installation
1. If the engine is on the vehicle, the starter is easier to access from underneath because it is located relatively low on the rear of the engine. If you...

Starter Repair — General Information
1. The starter motor designs that are installed are robust and strong, so it is very unlikely that you will need to disassemble the motor unless it is very...

Starter Solenoid — Removal and Installation
1. The Delco-Remy type solenoid is secured to the pinion housing with two mounting screws. Remove these two screws, remove the locking washers and disconnect...

Starter Motor Brushes — Checking and Replacing
1. Once the starter is removed from the engine and placed on a clean, level surface, begin by removing the cap from the end where the armature is located,...

Starter motor — disassembly and assembly
1. Complete disassembly of the starter motor is beyond the capabilities of the average DIYer, as it requires specialized tools and testing equipment, but if...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: