Car body exterior Opel Vivaro A

Hood — fastening
The hood is attached on both sides to hinges, which in turn are bolted to the body (figure 10.1). Figure 10.1. Hood.

Front wing
The front wing is attached to the body with bolts (arrows) (figure 10.2). When removing the front wing, you must also remove the water deflector panel and the...

Front door
Each of the front doors is mounted on two hinges, which are screwed to the front pillars and doors respectively (figure 10.3). The rod holds each door open at...

Front bumper
Front bumper, unpainted, made of grey plastic as standard, withstands impacts up to 4 km/h (2.4 mph). It is secured with screws (arrows) (figure 10.4). Figure...

Radiator grille
The radiator grille is made of plastic and is attached to the body with screws (arrows) (figure 10.5). Figure 10.5. Radiator grille.

Rear bumper
The rear bumper consists of a central part, which is made of grey plastic, and two side parts, also made of grey plastic (figure 10.6). The central part can be...

Lifting a car
The support points for installing the car on the lift are shown in the figure 10.7. Figure 10.7. Support points for installing the car on the lift.

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: