Power electrical equipment Opel Zafira A (petrol)

Battery — reference data
Table 14.2. Technical characteristics of storage batteries Table 14.3. Tightening torques for threaded connections

Battery — Removal and Installation
In vehicles for countries with cold climates, a thermal insulation cover is installed on the battery, which protects the battery from temperature changes,...

Battery — Maintenance
To complete the work you will need: devices for stripping battery terminals and wire terminals; voltmeter; charger. When servicing the battery, it is necessary...

Generator — reference data
Table 14.5. Basic data for control, maintenance and repair * Depending on the model. Table 14.6. Tightening torques for threaded connections

Description of the generator design
The vehicle is equipped with a three-phase alternating current generator with electromagnetic excitation, a diode rectifier unit and a built-in voltage...

Generator — testing without removing from the car
Note: If the battery charge indicator lamp on the instrument panel does not light when the ignition is turned on, there is most likely a break in the circuit...

Generator — replacement
This section describes the operations for removing two different alternators from the Astra and Zafira models. Depending on the configuration and year of...

Voltage Regulator and Brush Assembly — Replacement
The necessity of performing this operation should be determined when checking the generator (see " Generator - testing without removing from the car ")....

Starter — reference data
Table 14.13. Basic data for control, maintenance and repair Table 14.14. Tightening torques for threaded connections

Description of the starter design
Starter details: 1 - back cover; 2 - electric motor; 3 - pull-in relay; 4 - front cover; 5 - drive. The car is equipped with a starter with permanent magnet...

Starter — technical condition check
Note: You can check the electrical part of the starter without disassembling it. To perform the work you will need a multimeter. We perform the work with an...

Starter — removal and installation
The starter is secured with two bolts on the right side of the cylinder block at its rear. To carry out the work, you will need an inspection pit or overpass....

Solenoid Relay — Replacement
To complete the work you will need a TORX T25 key. Sequence of execution 1. Remove the starter (see " Starter - removal and installation "). 2. Using a 13 mm...

Starter — disassembly and assembly
Disassembly 1. Remove the starter (see " Starter - removal and installation "). 2. Remove the starter relay (see " Solenoid Relay - Replacement "). Note: If...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: