Removing
1. We prepare the car for work and disconnect the wire terminal from the negative terminal of the battery (see «Preparing the car for maintenance and repair»).
2. Similarly, disconnect the wire terminal from the positive terminal of the battery, after lifting up its protective cover.
3. Remove the thermal insulation cover of the battery by lifting it up.
4. Using a 13 mm socket wrench, unscrew the bolt securing the battery pressure plate.
5. Remove the pressure plate.
6. Remove the battery from the car.
Installation
Install the battery in reverse order. Before connecting, we clean the battery leads and terminals and apply a thin layer of conductive grease to them (see «Battery - Service»).
Warning! The conclusions of the battery are made different; the diameter of the positive terminal is larger. Reverse polarity when connecting the battery will damage the vehicle's electronic equipment.
To protect against environmental influences, we apply a protective varnish to the terminals with installed terminals.
Visitor comments