Manual transmission — reference data Table 10.2.1. Basic data for control, adjustment and maintenance Table 10.2.2. Tightening torques for threaded connections
Gearbox — checking the level and changing the oil We check the oil level in the gearbox during vehicle maintenance in accordance with the maintenance schedule (see « Periodic maintenance »), as well as if you...
Gearshift drive — removal, repair and installation The operation is necessary during the removal of the gearbox, and also if there is a need to replace the plastic bushings of the mechanism drive when they are...
Gear shift lever — replacement and adjustment Adjustment is necessary after replacing the drive lever, as well as in case of fuzzy gear shifting. Adjustment 1. We prepare the car for work (see « Preparing...
Shift rod oil seal — replacement The need to perform this operation must be determined during the check of the technical condition of the gearbox (see « Manual transmission - checking the...
Front wheel drive seals — replacement The need to perform this operation must be determined during the check of the technical condition of the gearbox (see « Manual transmission - checking the...
Gearbox — removal and installation Removing the gearbox is necessary to repair it or to replace parts of the clutch release drive. This operation is quite laborious and requires certain skills...
Transmission input shaft oil seal — replacement The gearbox input shaft seal is installed in the clutch slave cylinder housing. When the input shaft seal is worn, the oil from the gearbox enters the clutch...