Car gearbox repair Opel Astra J (petrol)

Design features of a manual gearbox
They are installed on cars (depending on the configuration) either a 5-speed manual transmission mod. F17-5 (Fig. 1), or a 6-speed automatic transmission mod....

Possible malfunctions of a manual transmission
Table 1. Possible malfunctions of a manual gearbox, their causes and methods of elimination Cause of malfunction Method of elimination Vibration, noise in the...

Features of the design of an automatic transmission
with an adaptive control system, it provides the choice of the optimal gear shift mode for almost any road conditions and driving styles. The automatic...

Checking the level, topping up and replacing oil in the gearbox
Periodically (but not less than once every 15,000 km) check the oil level in a manual gearbox or the working fluid level in an automatic. The design of the...

Replacing gearbox seals
To replace oil seals internal constant velocity joints (CV joints) drain the oil from the manual transmission or the working fluid from the automatic...

Removal and installation the gearbox
The main faults that require removing the manual transmission from the vehicle to fix are: elevated (compared to the usual) noise; difficult gear shifting;...

Disassembly and assembly of a manual gearbox
You will need: wrenches "10", "13", "19", "24", a set of Allen keys, flat-blade screwdrivers (two), round-nose pliers, a snap ring puller, a bearing puller, a...

Repair of secondary shaft of manual transmission
You will need: snap ring pliers, screwdriver, round-nose pliers, universal puller. 1. Press the rear bearing off the secondary shaft... 2. …and take it off. 3....

Repair of synchronizer of manual transmission
If the gear engages unclearly or with great effort or does not engage at all, before disassembling the secondary shaft, check the operation of the...

Repair of differential of manual transmission
One of the reasons for increased noise in the gearbox may be wear or breakage of differential parts. You will need: 15 mm socket head, universal puller,...

Replacing gearbox control cables
The replacement of control cables is shown using the example of a manual gearbox; the control cable of an automatic gearbox is replaced using practically the...

Removal and installation the gearbox control lever linkage
Shown is the removal of the gearshift lever linkage for a manual transmission. The automatic transmission selector is removed using almost identical...

Adjusting the gearbox control drive
The manual transmission control drive consists of two cables: gear selection and gear shifting, both cables are adjustable. No tools are required to adjust the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: