Car doors and windows Opel Astra G

Removal, installation and adjustment of doors
Door fit gaps The specified clearances for door fits in openings should be 4±1 mm (5-door hatchback is shown, - for other models the requirements are similar)....

Removal and installation the inner door handle
1. Remove the door interior trim panel (see Removal and installation of interior trim panels ). 2. Slide the handle assembly to release the latches and release...

Removal and installation the outer door handle
Front doors 1. To gain access to the handle, remove the door interior trim panel and the insulating plastic membrane (see Removal and installation of interior...

Removal and installation door locks
Front doors 1. Remove the door interior trim panel and the insulating plastic membrane (see Removal and installation of interior trim panels ). 2. Raise the...

Removal and installation front door lock cylinders
Front Door Lock Cylinder Installation Details 1 — Pin of the retaining spring 2 — Body 3 — Lock cylinder 4 — Bushing 5 - Ball 6 — Retainer 7 — Base of the body...

Removal and installation the door lock striker
The striker is bolted to the body pillar. 1. Before unscrewing the mounting bolts, mark the position of the striker on the stand. 2. To unscrew the bolts you...

Removal and installation of door glass
Front doors 1. Remove the door trim panel and plastic insulating membrane (see Removal and installation of interior trim panels ). 2. Raise the window...

Removal and installation the window regulator
Front door Front Door Window Regulator Installation Details 1 - Groove for regulator orientation 2 — Connector 1. Remove the front door glass (see Removal and...

Removal and installation the trunk lid (Sedan models)
1. Open the trunk lid completely. 2. On single lock models, disconnect the negative battery cable and the wiring harness from the lock actuator - if the old...

Removal and installation the trunk lid hinges
1. Remove the luggage compartment lid (see Removal and installation the trunk lid (sedan models) ). 2. Remove the rear decorative panel (see Removal and...

Removal and installation trunk lid components
Pen 1. Remove the luggage compartment lid (see Removal and installation the trunk lid (sedan models) ) and the cylinder of its lock (see below in this...

Removal and installation the tailgate (Hatchback and Station Wagon models)
Tailgate Installation Details (hatchback and Station Wagon models) 1 - Releasing the spring lock of the upper support of the door stop 2 - Knocking out the...

Removal and installation tailgate hinges
1. Remove the tailgate (see Removal and installation the tailgate (hatchback and Station Wagon models) ). 2. Carefully remove the rubber seal from the top edge...

Removal and installation tailgate components
Telescopic racks 1. Open the tailgate fully and ask an assistant to hold it. 2. Using a screwdriver, release the spring clips and detach the pillars from the...

Removal and installation the upper sunroof glass
1. Slide the sunroof all the way back and open the glass panel halfway. 2. Remove the four screws located at the front edge of the glass panel and remove the...

Removal and installation sunroof components
The assembly of the upper hatch is one of the rather complex components, including many parts. The authors of this Manual strongly advise against attempting to...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: