Front door
Details of installation of a regulator of a window regulator of a forward door
1 - Groove for the orientation of the regulator
2 - Connector
1. Remove front door glass (see Removal and installation of door glasses).
2. On models with power windows, disconnect the negative cable from the battery and the wiring from the regulator drive motor, disconnect the door wiring connector (see illustration Details of installation of a regulator of a window regulator of a forward door).
3. Drill out the rivets securing the power window regulator to the inner door panel and remove it through the lower hole - note that the lower part of the regulator is laid in the groove (see illustration Details of installation of a regulator of a window regulator of a forward door).
4. Installation is carried out in the reverse order - use new rivets to fasten the regulator. On models with programmable windows, set the window to the closed position on the control unit, to do this, sit in the driver's seat and close all doors, turn on the ignition and lower the windows, then raise the windows again and hold the control button pressed for at least two more seconds.
Rear doors
1. Remove the tailgate sliding glass (see Removal and installation of door glasses).
2. On models with power windows, disconnect the negative cable from the battery and the wiring harness from the governor drive motor.
3. Drill out four rivets securing the regulator to the door panel. Remove the regulator through the top hole.
4. Installation is carried out in the reverse order - use new rivets to fasten the regulator. On models with programmable windows, set the window to the closed position on the control unit.
Visitor comments