Removing
Remove inner door trim see 18.5.
Remove the water-repellent protective film from the door openings.
Power window in the front door
Raise the glass halfway and clamp it in the door charge with a suitable wooden wedge.
Unscrew window lifter from door (arrow).
Attention: Since January 1983, the power window has been rigidly fixed with rivets, see clause 18.12.
Pull the power window out of the guides.
Remove the power window from the mounting hole.
Power window in rear door
Unscrew the power window regulator at -A- and use the guide rollers to move it out of the lower guide.
Installation
Lubricate all sliding parts of the window regulator with a thin layer of Moly-paste.
Monitor the power window functions. Roller -1- in installation guide -A-, roller -2- in glass guide.
Install the window regulator through the mounting hole and screw it to the door trim.
Adjust the angle of the glass on the installation rail so that the top edge of the glass is parallel to the top edge of the glass frame.
Power window for tailgate
Install the guide rollers in the lower glass guide, screw the power window regulator.
Carefully stick a water-repellent film on the openings in the door.
Install the interior door trim see 18.5.
Visitor comments