Removal and installation the front door lock cylinder (Opel Kadett D)

Removal

Remove the inner door trim.

Partially remove the water-repellent protective film.



Disconnect the control rod -A- from the rod -6-.

Using a screwdriver, disconnect the clamps -B- from the lock cylinder housing (in the direction of travel, pressing forward).



Remove the lock cylinder from the hole in the door

Caution: To remove the lock cylinder from the housing, insert the ignition key into the lock cylinder.

Disconnect the leash -6- from the body.

Remove the lock cylinder from the housing; the ignition key must be inserted into the lock.

The source is on the online website opelbook

Caution: Do not lose the spring.

Caution: Before removing the ignition key from the lock cylinder, wrap the lock cylinder with tape to prevent the locking plates from falling out.

Installation

Insert the lock cylinder -2- with the ignition key -1- inserted into the housing -3-.

Install spring -5- and leash -6-.

Install seal -4- on the housing.

Insert the lock cylinder through the opening in the door and secure it with the clamps -B-. Connect the seal rod -A- to the leash -6-.

Carefully apply water-repellent film to the holes in the door.

Install the interior door trim.

Note: Since 1984, the lock number has been stamped on the trunk lock cylinder. To determine the key number, you must remove the lock cylinder.