Design and specifications Vehicles with engines «12SC», «13N», «13S», «14NV» equipped with a four- or five-speed gearbox, depending on the model «F10» with synchronizers in all forward...
Removal and installation of a transmission Removing Note. Removal and installation of gearbox shafts, as well as disassembly and assembly of the differential can be carried out without removing the...
4-speed gearbox device Details of 4-speed transmission type «F10»: 1 - input shaft; 2 - a block of gears of the input shaft; 3 - secondary shaft; 4 — a fork of switching of I and II...
Dismantling the 4-speed gearbox Install the gearbox on a stand for disassembly. Unscrew the plug of the vent hole of the gearbox housing from the cover of the gear shift mechanism. Remove...
Features of disassembling a 5-speed gearbox After removing the reverse light switch, proceed as follows. Remove the gearbox rear cover. Loosen the bolts securing the intermediate housing to the gearbox...
5-speed gearbox device Details of 5-speed transmission type «F10»: 1 - input shaft; 2 - a block of gears of the input shaft; 3 - secondary shaft; 4 - shift fork 1-11 gears; 5 - fork...
Differential disassembly Remove differential cover. Mark the position of the adjusting nut of the differential box bearing relative to the gearbox housing and, moving the differential...
Differential Assembly Install the satellites into the differential box using the KM 456 conductor, after putting the thrust washers in place. Install side gears with thrust washers...
Assembling the 4-speed gearbox Install the output shaft roller bearing outer ring into the gearbox housing using tools KM 453 and KM 454. Using tools KM 452 and KM 454, install the input...
Gearshift and differential drive device Parts of gearshift drive and differential: 1 — the handle of the gear lever; 2 - protective cover; 3 - gearshift lever; 4 - body; 5 - protective cover; 6 -...
Assembly features of the 5-speed gearbox After installing the synchronizer of I and II gears on the secondary shaft, perform the following operations: install the gear of the 1st gear and the needle...
Adjustment of a drive of a gear change Place the shift lever in the neutral position and remove the console, if equipped. Unscrew the clamp bolt on the gearshift linkage and remove the adjusting...
Removal and installation of the gear lever Removing Place the shift lever in neutral, remove the console, if installed, and lift up the protective boot. Remove the retaining ring from the groove of the...