Electrical equipment and devices of car Opel Kadett D
On-board electrical equipment — general information
The electrical equipment of the OPEL KADETT is powered by a direct current of 12 V. The source is an alternating current generator with a device for regulating...
The electrical equipment of the OPEL KADETT is powered by a direct current of 12 V. The source is an alternating current generator with a device for regulating...
Instructions for installing additional equipment
After drilling or punching holes in the body, their edges must be cleaned and painted. The chips that arise during drilling must be removed. In particular,...
After drilling or punching holes in the body, their edges must be cleaned and painted. The chips that arise during drilling must be removed. In particular,...
Maintenance of electrical equipment
Electrical equipment requires systematic testing of various units. Testing should not be neglected, since the safety of the vehicle depends on electrical...
Electrical equipment requires systematic testing of various units. Testing should not be neglected, since the safety of the vehicle depends on electrical...
Replacing fuses
To prevent short circuits and overloads in wires and electrical devices, individual circuits are protected by fuses. The OPEL KADETT uses fuses that meet the...
To prevent short circuits and overloads in wires and electrical devices, individual circuits are protected by fuses. The OPEL KADETT uses fuses that meet the...
Fuse box table
The fuse box is located inside the passenger compartment to the left of the steering column. Fuses of various ratings are used to protect individual electrical...
The fuse box is located inside the passenger compartment to the left of the steering column. Fuses of various ratings are used to protect individual electrical...
On-board electrical equipment instruments — general information
All instruments in the OPEL KADETT D are combined in the instrument cluster. By removing the instrument cluster, individual instruments or control bulbs can be...
All instruments in the OPEL KADETT D are combined in the instrument cluster. By removing the instrument cluster, individual instruments or control bulbs can be...
Removal and installation the instrument panel
Removal Disconnect the ground wire. Remove the speedometer shaft. To do this, press the locking spring down under the instrument panel at the back and remove...
Removal Disconnect the ground wire. Remove the speedometer shaft. To do this, press the locking spring down under the instrument panel at the back and remove...
Checking the voltage stabilizer
Disconnect the coolant temperature cable from the temperature sensor. Turn on the ignition. Caution: The removed cable must not come into contact with ground....
Disconnect the coolant temperature cable from the temperature sensor. Turn on the ignition. Caution: The removed cable must not come into contact with ground....
Removal and installation light bulbs
Remove the instrument panel housing, see above . Control lamp holders for serial equipment A - Battery charging indicator light. B - Oil pressure indicator...
Remove the instrument panel housing, see above . Control lamp holders for serial equipment A - Battery charging indicator light. B - Oil pressure indicator...
Removal and installation of devices
Removal Remove the instrument panel housing. Unscrew the front part of the instrument panel housing. A - fuel quantity indicator. B - remote thermometer. C -...
Removal Remove the instrument panel housing. Unscrew the front part of the instrument panel housing. A - fuel quantity indicator. B - remote thermometer. C -...
Turn signal switch and windshield wiper switch
Removal Disconnect the ground wire. Remove the upper steering column support trim. Remove the lower steering column support trim. Remove the turn signal switch...
Removal Disconnect the ground wire. Remove the upper steering column support trim. Remove the lower steering column support trim. Remove the turn signal switch...
Removal and installation the fan motor
Removal Disconnect the ground wire. In cars with sound insulation, remove additional sound insulation. Using a screwdriver, remove the fan motor housing cover...
Removal Disconnect the ground wire. In cars with sound insulation, remove additional sound insulation. Using a screwdriver, remove the fan motor housing cover...
Removal and installation the windshield wiper arm
Removal The windshield wiper arm is removed using a special tool. If you do not have such a tool, the windshield wiper arm is pressed with a screwdriver....
Removal The windshield wiper arm is removed using a special tool. If you do not have such a tool, the windshield wiper arm is pressed with a screwdriver....
Removal and installation the windshield wiper motor
Removal Disconnect the multi-pin connector -A- from the windscreen wiper motor. Unscrew the windshield wiper crank from the engine. Unscrew the windshield...
Removal Disconnect the multi-pin connector -A- from the windscreen wiper motor. Unscrew the windshield wiper crank from the engine. Unscrew the windshield...
Removal and installation the windshield wiper
Removal Remove the windshield wiper arms. Unscrew the windshield wiper support nuts. For this purpose, use a socket wrench that fits into the groove of the...
Removal Remove the windshield wiper arms. Unscrew the windshield wiper support nuts. For this purpose, use a socket wrench that fits into the groove of the...
Additional installation of adjustable outside rearview mirror
The outside mirror is installed in the right or left front corner of the window. Remove the rubber guide from the front corner of the window. Remove the outer...
The outside mirror is installed in the right or left front corner of the window. Remove the rubber guide from the front corner of the window. Remove the outer...
Installing the antenna
The rod antenna is mounted on the right wing and is attached to the side wall using a holder. Installation Drill a hole for the antenna according to the data...
The rod antenna is mounted on the right wing and is attached to the side wall using a holder. Installation Drill a hole for the antenna according to the data...
Installing a Loudspeaker on the Dashboard
Remove the blind cover or clock from the instrument panel. Remove the air duct from the middle deflector. Unscrew the heating switch. Set the switch to the...
Remove the blind cover or clock from the instrument panel. Remove the air duct from the middle deflector. Unscrew the heating switch. Set the switch to the...
Installing a radio receiver
Disconnect the ground cable from the battery. Unscrew the two screws for fastening the ashtray (arrows), detach and remove the lower side of the ashtray. Press...
Disconnect the ground cable from the battery. Unscrew the two screws for fastening the ashtray (arrows), detach and remove the lower side of the ashtray. Press...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
See similar ones from other Opel car manuals:
▶ Electrical equipment: Equipment and devices Opel Zafira A (1999-2005, petrol)
▶ Electrical equipment: Equipment and devices Opel Omega B (1993-1999)
▶ General information: Vehicle device Opel Corsa C (2000-2006)
▶ Electrical equipment: Equipment and devices Opel Vectra C (2002-2008)
▶ Electrical equipment: Equipment and devices Opel Vivaro A (2001-2014)
▶ Electrical equipment: Equipment and devices Opel Zafira A (1999-2005, petrol)
▶ Electrical equipment: Equipment and devices Opel Omega B (1993-1999)
▶ General information: Vehicle device Opel Corsa C (2000-2006)
▶ Electrical equipment: Equipment and devices Opel Vectra C (2002-2008)
▶ Electrical equipment: Equipment and devices Opel Vivaro A (2001-2014)
Share information:
- General information
- Vehicle description
- Operation and maintenance
- OHV power unit
- Engine design
- Check and repair
- Engine work
- OHC power unit
- Engine design
- Engine repair
- Ignition system
- Cooling and lubrication
- Supply system
- Fuel injection «LE-Jetronic»
- Fuel injection «LE3-Jetronic»
- Motronic ML4.1 system
- Motronic M1.5 system
- Motronic M2.5 system
- Transmission
- Clutch
- Gearbox F10 and F13
- Gearbox F16 and F20
- Automatic gearbox
- Drive shafts
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Electrical equipment
- Equipment and devices
- Electrical circuits
- General information
- Car care
- Maintenance
- Power unit
- Gasoline engines
- Lubrication system
- Cooling system
- Power system (gasoline)
- Carburetor Solex 35 PDSI
- Carburetor Varajet II
- Carburetor 1B1
- Fuel injection (gasoline)
- Diesel engines
- Fuel system (diesel)
- Transmission
- Clutch
- Manual gearbox
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Wheels and tires
- Body
- Body elements
- Doors and windows
- Electrical equipment
- Equipment and devices
- Lighting system
- Power devices
- Ignition system
- Electrical circuits