General description of onboard electrical equipment System type - 12V, with grounding on the negative pole. Note: The list of electrical equipment installed on the vehicle is determined by the configuration of a...
Troubleshooting electrical equipment Caution: The procedures described below can be used to troubleshoot simple electrical circuits not related to electronic control circuits. In addition, they...
Fuses and relays — location and purpose Color identification of fuses by rated current Small fuses Large fuses Fuse color Current strength Fuse color Current strength Violet BEHIND Green 30 A Beige 5...
Replacing fuses 1. Various combinations of fuses, circuit breakers and fuse links can be used to protect the contact circuits of the vehicle's electrical equipment. 2. On the...
Relay — general information and health check General information 1. To supply power or control signal to some of the electrical consumers in the vehicle (such as fuel injection components, horn, starter,...
Removal and installation of a sound signal 1. The horn horns are installed in the engine compartment, one under each of the headlights of the car. 2. Disconnect the wire from the negative terminal of...
Removal and installation of a tank and the washer pump 1. Remove the left front wheel and the left front wheel arch protection ( see chapter 11 ). 2. Disconnect the wiring (see resist. illustration) and disconnect...
Removal and installation of a combination of devices 1. Disconnect the wire from the negative terminal of the battery ( see chapter 5 ). 2. Remove the upper and lower steering column covers ( see chapter 11 ). 3....
Removal and installation of the information display Note: The status of the information display is checked using a special diagnostic tool. Based on this check, the need to replace it is determined. 1. The...
Removal and installation of the cigarette lighter 1. Disconnect the wire from the negative terminal of the battery ( see chapter 5 ). 2. Remove the ashtray with the mounting body ( see chapter 11 ) and remove...